Autoclaved aerated concrete cutting machine Tilting Hoister attached with Auto crane

Tilting Hoister attached with Auto-crane

Description:

It is installed on the automatic billet shift machine, the moving and lifting is rely on auto-crane. The lifting is guide by the guidance frame. It has the advantages of stable, accurate, no excursion, no shaking. It is a special hoister to open, assemble the mould and demould.

The tilting hoister (see the picture) is a match equipment for autoclaved aerated concrete cutting machine.
Uses

The hydraulic station supplies the oil to the turning cylinder to make the clamp device turn 900 and the clamp arm turn left means to tighten and loose when turn right.
?

Quick-wear parts

The hydraulic station supplies the oil to the tilting cylinder when the hanger is lifting and pushes the pistol to tilting the mould.Clamp and loose The hanger lift the slide wheel on the cross beam, and the guide device on the vertical beam moves down.
Tilting

The?vehicle?moving?to?make?the?hanger?goes?and?returns?along?the?shaft?direction.

Go?up?and?down

The?tilting?hoister?has?the?functions?of?moving,?lifting,?turning,?clamping?side?plate?and?de-mould.

MovingThe?tilting?hoister?is?composed?of?beam,?guide?device,?turning?device,?lifting?device,?side?panel?

clamp,?loose?device?and?hydraulic?station.?The?beam?is?made?of?rectangle?steel?pipe?with?good?rigidity,?

simple?structure?and?it?is?easy?to?install?and?adjust.?The?hydraulic?station,?lifting?device,?side?panel?clamp

?and?loose?device?is?placed?on?the?top?of?the?cross?beam?and?the?turning?device?is?place?on?the?vertical?

beam.

Working?principles

type:dia=40mm,?Stroke=87mm?

nos:2

Structure

type:dia=63mm,?Stroke=400mm?

nos.:2PC

locking?oil?cylinder

type:dia=100mm,?stroke=431mm?

nos.:2PC

mould?locking?oil?cylinder

Length:7955mm????width:1193mm???height:according?to?stroke

weight:~3800kg driving?system

max?dimensions Technical?parameter

The?tilting?hoister?has?2?functions.

Lifting the mould with cake and side plate to the air after pre-curing, tilting 90 degree (the cake is vertical) and then lifting to the cutting cart, open the mould and demould, remove the mould, the cake are prepared for cutting.? The mould after removed from the cake assemble with the side plate and then tilting 90 degree in the air and put in the return track, again it is ready for pouring.