Stainless Steel Conical Strainer For Water Meter Made By SS304 / Flange Strainer

Stainless Steel ?Conicalness Strainer Made By SS304 With flange

FEATURES
? ?Iron strainers are complete with Flat Face?(Series 125YF) or Raised Face (Series 250YF)
? ? flanges in accordance with ASME B16.1.

? ?Strainer body meets applicable ASME?Standard.

? ?One piece cast body.

? ?Strainers equipped with bolted cover?flange that utilize a flat gasket seal.

? ?Low pressure drop.

? ?Upper and lower machined seats.

? ?304 SS perforated screens are standard.

? ?Drain/Blow-off connection furnished with?plug as standard.

? ?Generous screen area and properly?proportioned straining chamber to?minimize initial pressure

? ? drop while?maximizing time between cleanings.

? ?Compact end to end dimension.

Brief?introduction:

The?strainer?may?be?used?on?all?types?of?pipelines?to?collect?granulated?foreign?substances?and?

contaminants?collected.?It?can?improve?the?clearance?in?the?medium,?and?prolong?the?life?of?valves?

and?other?equipments.?It?is?suitable?for?wafer,?petroleum?and?steam.

Mail?part?&?material?

Body:?gray?cast?iron,?cast?iron,?ductile?iron?

Filter:?stainless?steel?

O-ring:?NBR?

Technical?Specification

- Nominal?diameter:65～500mm????????

- Nominal?pressure:1.0/1.6/2.5Mpa

STRAINER INSTALLATION INSTRUCTIONS
A . Ensure all machined surfaces are free of defects and that the inside of the
strainer is free of foreign objects.
B . ?For horizontal pipelines, the strainer should be installed so that the drain
connection is pointed downwards.
C . ?For flanged end strainers, the flange bolting should be tightened gradually in
a back and forth clockwise motion.
D . ?Once installed, increase line pressure gradually and check for leakage around joints
E . ?If the strainer is supplied with a start-up screen, monitor pressure drop carefully.