LKM Base Plastic Injection Mould PU Cold Runner For Swim Goggles

Quick Detail:

1. The part name: swim goggles? (plastic injection mold)

2. Plastic material: PU (elastic plastic)

3. Cavity material: H13 HRC48-52

4. Mold life: 1000k shots or according to customers quantity condition to decide it with saving cost for our customers.

5. Gate type: edge gate according to our customers requires.

6. Mold base standard: LKM Local standard, DME or HASCO,Customize according to customers\' requirements

7. Standard of mold accessories: LKM, DME, HASCO, MISUMI, Meusburger, CUMSA, Progressive, INCORE, HRS, Husky, YUDO, PETS, MOLD-MASTER, MERKLE, Parker, HPS, LKM, EUCHNER, RJG, cilpres, NITTO, CRACK, ASSAB, GSW DIN standard, BOHLER, AISI standard, DAIDO JIS standard, PUNCH etc according to our customers requires.

Description:

The part name: swim goggles

Mold type: plastic injection mold

Part Material: PU(elastic plastic)

Locating ring Dimension: Ф3.99\",

KO Pattern: 7”x7”,

Sprue Radius: SR 1/2\"

Ejection type: ejection pin.

Mold construction description: cold runner system, 2 plates, cavity insert need to pull out as mold open, moreover, two sliders first move, the other two sliders later move, then the product is ejected by the whole core, when mold close, the two sliders move firstly will later move, total 4 angle sliders, cavity ejection, core ejection.

This part has very high appearance requirements, the defect showed below will not be acceptable, for example, weld line, Dark Sport,Sliver Marks,Gas Trap Effect,Visible Ejector Marks,Deformation,Short shot Filling,Burnt Streaks,Sink Marks,Flash,Over dimension,Under dimension,Stress Crack etc. Moreover, the product finishing surface must meet the requires more than SPI-SPE B-2.

This mould is made in Shiny Mould Factory. It is a mould exported to USA, with complicated structures and high quality requests. Customer needs mold life to be over 1 million shots. We can ensure this mold life and give warrant to our customer that once some mould components are broken during working, if it is caused not by the operation fault from the workers, we can provide new mould components to them free of charge.

Specifications: