Medical Fiberglass Casting Tape Waterproof for Repair A Leg / Arm , Cast And Splint

Fiberglass Casting Tape for Medical or Art Used To Make Or Repair A Leg Or Arm Cast

Casting tape at an economical price for the perfectquality casting tape. ?13 redesigned colors creating strong , durable fiberglass casting tape for a superior look and feel. ?Easy application over the many angles of the limb creates the perfect contoured cast.

Character & advantage

1) ?Simple operation?: Room temperature operation , short time , good molding feature

2) ?High hardness & light weight

? ? ?20 times hard than plaster bandage ; light material and use less than plaster bandage ;

? ? ?Its weight is plasters 1/5 and its width is plasters 1/3,which could reduce wound burden

3)??Lacunary (many holes structure) for excellent ventilation

? ? ?Unique knitted net structure make sure good air ventilation and prevent skin damp and hot & pruritus .

4)? Rapid ossification (concretion)

? ? ?It ossifies in 3-5 minutes after open the package and could bear weight after 20 minutes , but plaster bandage need 24 hours for full concretion

5) ?Excellent X-ray penetration

? ? ?Good x-ray penetration ability makes X-ray photo clearly without remove the bandage , but plaster bandage need remove to make x-ray inspection .

6)?Good waterproofing quality

? ? The moisture - absorbed percent is 85% less than plaster bandage , Even the patient touch the water situation , it still could keep dry in the injury position

7)? Convenient operation & mold easily .

8) ?Comfortable & safe to patient / doctor

? ? Material is friendly to operator and it wont become tension after concretion .

9) ?Wide application

10)?Environment friendly

? ? ?Material are environmental friendly , ?which could not produce polluted gas after inflammation .

Size:

How to use Casting Tape

1) ?Put the pad (cotton coil or cotton slipcover) on the surgery position?.

2) ?Wear surgical gloves .

3) ?Select proper specification according to the surgery position .

4) ?Immerse the roll in room temperature water (21°C - 24°C) for 4 - 6 seconds and squeeze it 2 - 3 times firmly . ?If the water warmer than 21°C - 24°C shortens the immersing time , while cooler than 21-24°C water lengthens the time .

5) ?Enwind spirally ; Overlapping the previous layer by one-half or two-thirds of the roll width . To maintain proper tension is very important and take care to avoid excessive tightness . The strength can be determined by the number of layers used . Just 3-4 layers provide a string non-weigh-bearing cast and 5 - 6 ?layers are typically adequate for weight-bearing cast .

6) ?Additional after the initial enwinding should be overlapped on itself to achieve good molding . Enwind the roll in 3-5 minutes after immersing in water because after that time it will be concretion .

7) ?Smooth and rub the surface to achieve good contact between layers . Keeping smoothness helps mold the wrap .

Allow about 10 minutes for sufficient concretion and let patients not move during this time . It could bear electric weight after 20 minutes .

8) ?It could be windowed , trimmed or removed with traditional cast saw equipment?.

Precaution Please apply the surgical rubber gloves when you operate the product.When the resin is stuck to operator , please wipe it out with cotton swab with acetone .

Storage :

Be careful not to break the package .

Store ?Cast ?tape at room temperature .

Damaged products by careless handing cannot be replaced . Please handle and store them carefully?

The shelf life of ? Cast tape ?is 3 years from the day