Good Performance Coal rods briquette machine

Coal rods briquette machine

1. 1.     Productintroduction:

It’sthe name of the coal-rod forming machine: Coal rod machine, coal-rod machine,hollow coal rod machine is the principle of screw extrusion, which will bemodulated by the coal powder with certain strength.

1. 2.     Workingprinciple:

Therotation of the impeller from the feeding port with coal, coal and coal willmove forward, gradually compressed, and produce particles, close together,stirring and mixing is relatively large. At this time, the coal particles,particles and the blade and the cylinder produce strong friction and shear, andat the same time in the role of heat, the coal temperature rise, water andbinder more uniform, the plastic is also greatly increased, and then throughthe control of mold cone shape, coal grain compression between the moreclosely, and then press into the flat parts of the mold, out of coal rodmachine and molding.

Coalrod machine adopts Hardened reducer, small volume, and high bearing capacity.Coal rod extrusion machine inside the impeller adopts thickening blade design,impeller and cylinder body is lined with wear resistant casting material and,life than ordinary steel improve 4-5 times. The head of the coal rod machineexport with replaceable wear resistant alloy steel production, the replacementis convenient. Head and cylinder in the form of hinge, maintenance can beopened; replacement within the impeller and cylinder liner is very convenient.

1. 3.     Installationand commissioning:

2. 1.Before the installation of spare parts must be thoroughly cleaned, removal oftransport or storage for a long time to appear rust, and check parts is notdamaged.

3. 2.According to the basic map on the basis of concrete pouring, and concretescrew, after the solidification of the coal rod machine dipping in concretebased on screw alignment, two concrete grouting, anchor bolts to be solidified,correct the machine level, the machine can be stable test machine. Before thetest machine will be the lubrication of lubrication, oil content is moderate.Check all the bolts if there is a loose phenomenon, and tighten. Point to movethe machine to see if there is a foreign body or abnormal sound. All confirmedthat no party can start running. And check the power direction is correct. Themachine idle for 3~5 minutes, then all the normal feeding trial, new machinefeeding should be uniform, moderate (wet and dry water generally contain12%~15%).

1. 4.     Useand maintenance:

2. 1.       Everyshift before starting to check whether the rotation is flexible, there is noabnormal sound, empty machine running 2~3 minutes to feed production.

3. 2.       Rawmaterials must be processed, the maximum particle size of less than 3mm, addingwater, adding binder, curing agent, can be used by mixing retting after 24hours.

4. 3.       Feedthe blockage, using wood or bamboo dredge, avoid the use of metal bar.

5. 4.       Themachine rotating part of the bearing should be regularly injected into thelubricating oil; bearing part of the temperature is not more than 60 degrees.

6. 5.       Stopbefore the end of the material, the cylinder in the air after the extrusion ofmaterial, the demolition of the machine head, after washing, to prepare forwork.

7. 6.       Inorder to make the motor not exceed the load operation, it is recommended thatthe user to install the current voltage meter, according to the current meterto adjust the amount of material and water content.