Fully Automatic High Speed Non Woven Fabric Cutting Machine For Spunlace Cloth

Fully Automatic High Speed Non Woven Fabric Cutting Machine For Spunlace Cloth

Description:

Equipment can be slitting rewinding spunlace cloth, wood pulp cloth, non-woven, meltblown, Jakob, spunbond nonwovens and, using high quality servo control system to adjust the line length, product cutting neat without burr, the machine for processing core or coreless, hit or not hit the line slitting rewinding products, a machine, according to customer product requirements replace equipment configuration

Specification:

Features:

1 Equipment requirements: drilling, counting (touch screen digital display), and then cut, the volume at the same time.

2 Machine tool axis, the effective width can be customized, servo motor, anti interference system with synchronous belt drive, drilling tool axis spiral line (punch specific specifications size by the customer), light and smooth, and can adjust the angle of the pitch, the hole can be adjusted from above 10CM (touch screen digital set can be;

3 Cutting knife shaft, and the collection of a servo motor with a servo motor with belt drive; knife shaft material hardness and toughness should be strengthened, so as to achieve the replacement of the upper and lower knife must be simple, convenient.

4, equipment, cutting knife, cutting knife to add a guide roller device, guide roller material selection of aluminum alloy material, diameter is not less than 80mm, can rotate freely;

5, The winding roller, and shear cutter shaft combination of a servo motor with synchronous belt transmission; two rolling roller diameter respectively is 220mm, second received roll in which a root driven roller is equipped with gear type stepless speed variator control rewinding roller speed.

6 The air pressure of the winding roller. The two side with two cylinder pressure adjustment device, gas - up - shaft, stainless steel shaft.

7, The machine is divided into three parts, drilling device, cutting device, the device connected to a whole (equipped with 3 servo motor), each part of the roller shaft with 38mm thick steel plate as the device two side of the supporting frame, the surface of the bearing, bearing in the bearing sleeve, and then embedded within the steel plate.

8, Electrical part of the use of PLC module programming, computer touch screen control, put the volume part, the point cut into the hole, cut into parts of the three parts of the motor with encoder and PLC programming, before and after each part can be adjusted separately.

9, Gas expansion shaft unwinding, the available wire rod shaking regulator regulates unwinding edge correction. Cloth gas dynamic automatic coiling (rocker arm into the minimum ground 10cm).

10, Production core coreless roll type products, drilling rewinder or perforated rewinder, console available touch screen operation is also available potentiometer button operation of double operation control.

12 Product cutting width in the 30mm above can be adjusted, the maximum diameter of the product 400mm (400mm can be adjusted), with online cutting knife 15 sets, in a certain range can be adjusted to cut the size of the. Company to provide customers with a variety of rolling, winding way, magnetic powder rose control, horizontal force control, co