Dimmable 1-10V 350mA - 900mA LED Driver 40W With Memory Function

1-10V Push 40W 350mA - 900mA Dimmable LED Driver ?for LED panel light?

Description:

1,?Press-in terminals in primary and secondary side, easy assembly.

2, Long life span 50,000h, 5 years guaranty.

3, with 1-10V and push in PRI and SEC side.

4, no flickering from 0%-100% dimming level

5,The output currents from 350mA to 900mA. It can be set by DIP swiches.

6, Jumper design for switching different dimming modes, it is very?convenient?to?select suitable dimming function as you required.

7, Memory function: The driver has built-in permanent memory against power failure. Lights can return to previous dimming level when switch off and on again, even at mains restores.

8 Synchronization: thanks to the MCU programme, up to 50pcs drivers should be controlled by the same switch. This means there is no need for any additional synchrony wire in larger installations, where many drivers should be controlled by one switch.

9, Maximum length of the cable, from switch to last driver is 20m.

10, Factory setting: 100% dimming level and 350mA output.

11, Reset the LED diver easily by a jumper.

12, Protection: Short circuit / Over voltage / Over temperature.

Dimming Operation:

A) PUSH Dim

Primary and secondary dimming with PUSH button. It has dimming level memory at main rstore. And the push dim is alway prior.

B) 1-10V Dim

Using the push dimming will make 1-10V dimming inactivated. The driver has to be reset to active the 1-10V dimming function again.

Synchronization:

For the resynchronization to work correctly when more than one driver is connected to the same push button, follow steps of below after the drivers are connected:

A) Press push button for more than one second, followed by a short push (<1s), now, led light switches off.

B) Do a long push, the system will be resynchronized.

Specifications