Activated carbon vibrating shaker

Introduction

This name is all vibrating screening equipment products collectively, the exact point of speaking of this circular vibrating screen according to national standards called "vibration sieve", due to its operating principle of many companies vibration called "three million vibration screening filter."

Activated Carbon Vibrating Shaker works principle: 

It by vertical vibration motor as the excitation source, the motor and lower ends mounted eccentric weight, the rotary motion of the motor into a horizontal, vertical, inclined three dimensional movement, then this movement is transmitted to the screen surface. The regulation, the phase angle and lower ends, you can change the trajectory of the screen surface material.

Shaker using the industry

Chemical industry: resin, paints, industrial chemicals, cosmetics, paint, medicine powder. 
Food industry: sugar, starch, salt, rice flour, milk powder, milk, egg, soy sauce, fruit juice. 
Metal Mining: aluminum powder, lead powder, copper powder, ore, alloy powder, welding powder, manganese dioxide, copper powder, magnetic power, abrasive powder, refractory materials, kaolin, limestone, alumina, carbonate, heavy calcium, silica sand. 
Pollution treatment: waste oil, waste water, wastewater dyeing, additives, activated carbon, etc.

New sieve separate design advantage
1.Save time(3-5 minutes to complete screen replacement).
2.Save manpower, for change screen just two people.
3.Increase fluency production line.
4.Increases screen life, bouncing ball does not directly strike a fine mesh.
5.Increase the screen using the area.
 This machine is very simple and quick method for change screen,just follow the order shown below, no more than five minutes, can be done for change screen.

installation and commissioning
1. Equipment shall be the basis of stability. When the equipment is installed on the general ground or cement foundation, you can not set the anchor bolts. When the equipment is installed on top of the steel structure of the gantry, the application bolt on the structure, but there should be a steel gantry steel degrees. 
The machine only a three-phase switch (Note: It is best to use electrical control panel), with snakeskin pipe threading, the motor can be connected to the power supply, that the electrical control panel should be installed on a wall hanging. 
2. The factory (two) devices will screen installed properly, the process of using a screen replacement may themselves be replaced. 
Before (three) boot, you should first check the tightness of all bolts, and whether various spout position catcher on the positive, and see if the vibration motor can rotate properly and the spring force or without obstacles, check the layer mesh are pressed. 
3. Before vibration sieve access electrical control panel, you should first check the electrical control panel. Line after turning observe whether the vibration motor rotation direction is clockwise (Note: otherwise should change the phase sequence) is functioning properly, there is no different noise. 
4.adjusting the phase angle of the upper and lower eccentric vibration motor block to accommodate a variety of materials screening situation.
 
If you want to know more information about our product, please reference