Waterproof 100 Meter Diving Headlamp , Aluminum Diving Flashlight

Waterproof 100 Meter Diving Headlamp , Aluminum Diving Flashlight

Specification:

BATTERY INSTALLATION

BATTERY CHARGING

1.Plug the charger in the wall power socket, the indicator light is green in the free-load status.

2.Put the battery in the slot of the charger.

3.The indicator light is red if the battery is not fully charged; it will turn green after fully charged.

4.Take out the fully charged battery and use them in the canister.

ON/OFF

Push the switch forward to activate the light.

The switch will go back to original position automatically.

MODES CHANGING

Successive switch ON-OFF within two seconds to cycle through high, low, strobe.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION

If the light is not to be used for some time, remove the batteries to prevent possible leakage or corrosion. Please remove the batteries during transportation to prevent it from misoperation.

WARRANTY RETURN POLICY

Please contact your local distributor or retailer for information on how to handle your warranty items.

REPLACEMENT PARTS

CAT#????????????????????? DESCRIPTION

DH258?????????????????? O-ring

DH259?????????????????? Lens