High-end Establishments Flap Barrier Gate Turnstile Connected RFID Pedestrian

Flap Gate Function

Self-reported failure prompts function

Traffic lights and channel indicator function

Normally open button function

Flap arm open automatically when power off and close when power on

Line self-test function

Illegal intrusion alarm function

Pinch protection function with mechanical, electronic and slip

Control access and free access can be adjusted

RS 588 Bridge Oblique Angle Flap Gate

Model: RS 188?Bridge Oblique Angle Flap Gate

Dimension:1200*300*1000MM

Material:304 stainless steel

Channel Width: folio<1200mm

Working Mode: Single/ bi-direction (adjustable)

Read/Write mode: IC/ID/magnetic card/barcode/fingerprint, etc.

1. Automatic open when power off, self-check when on power and recovery lock condition automatically.

2. Multiple work mold for selection. Read card two-way or one side read card, one side stop access, or one side reader card, one side go though. also can detected by IR at one side or double side, close barrier by IR detecting way after person go though. Motor work way can be set by main menu of main control broad.

3. Barrier will closed automatically or closed after delay some time when IR checked that person has go though after reading valid card. Delay time duration is from 1-60s.this function can be set though main menu.

4. With automatic reset function. system will cancel person limitation automatically. And the passing time can be set by person automatically.

5. If passenger forget read or read invalid card for access, system will alarm passenger and stop forbidding go until passenger back to channels, alarm will be release, go though after reading valid card again;

6. With RS485 to control open/close gate to meet customers especial requirement and fire fighting requirement.

7. Anti-collision function,telescopic boom will locked automatically before not receiving open gate signal;

8. IR/Machine double protection function,when IR check passenger in between, telescopic boom will not closed. It will closed automatically after passenger left. When arm overload stock within reset position ,bounce automatically or stop work within schedule time with small power and send alarm signal at same time;

9. With standards electrical interface, it can connect to any read/write equipment to easy for system integration. and also can though PC for remote control and management.

10.Can statistic the passenger`s quality automatically and use LED way (selection)send to manager, and then manager can know about passenger`s quantity of some direction.

11. With specific direction indicator function,though LED to indicate the way to access or stop .

12. With memory/without memory way can be select when reading card and user can set on control broad in according to their requirement.

13. Though software setting to limit the quantity of inner passengers to meet some special requirement.

14. The whole system work stably ,low noise.

15. With fault self-check and alarm notice function, easy to use and maintenance.