Hot Selling Injection mould Plastic Components

Hot Selling Injection mould Plastic Components

Die in the design, the design of locking force values. Before plastic mold components must set up the clamping force in plastic mold components machine. For different mold, the size of the clamping force is different. In the locking force, clamping force is not the bigger the better, but should combine plastic mold components and injection machine size, and design a touch and products to consider. From the analysis of economy and technology, numerical clamping force should be as small as possible, but must meet the need of plastic mold components products. For example, plastic mold components clamping force is low, can reduce the degree of wear of plastic mold components machine and mold, reduce energy consumption and repair costs. The clamping force can be smaller with the following methods, the first plastic mold components machine to mold the maximum clamping force disease to produce products, and then to 5T balance gradually reduce the clamping force reproduction, measured each clamping force under the weight of finished product, draw curve, find out the best parameters of clamping force on.

mouldzeng is here to serve you! 

Contact Yize Mould

Dongguan YIZE MOULD Co.,LTD

Address: Hexing Road No.122, South Shatou District, Chang'an Town, Dongguan City, Guangdong Province

TEL: 0769-81888 522  

FAX: 0769-81888 548

Website:

E-mail: Jack@dgyize.com