CR / HR Steel Hydraulic Cutting Machine ZJX-0.5-1.5X1250 With Tension Device

CR / HR Steel Hydraulic Cutting Machine ZJX-0.5-1.5X1250 With Tension Device

?
Description

1. Hydraulic entry coil car???????????????????
? ◆The car can move levelly and vertically, which is convenient for putting the steel coils into the de-coiler.
? ◆It is driven vertically by hydraulic cylinder with four guide pillars. ??
? ◆The level movement is driven by cycloid motor .
? ◆The capacity it can carry is 8 Tons(MAX).
?

?
?
2. Hydraulic cantilever un-coiler
? ◆Supporting steel rolls and uncoiling.
? ◆It can expand and shrink with hydraulic oil cylinder and fit with the inner hole of the steel coils and is equipped with supporting stand.
? ◆7.5kw motor drives the coils running and the motor can run right and left to prevent the coils running by inertia.
? ◆The capacity it can carry is 8 Tons(MAX).
?

?
?
3. Slitting machine
? ◆Power part: This is composed of power-stand, decelerator, 15KW direct current motor, gear distributing case, coupler, spindle, connecting-cover, side guide device, etc.
? ◆Host machine: This is composed of bottom-stand, fixed bracket, big slide, knife pivot (φ120mm, 2pcs), movable bracket, slide, the front and back adjustable device of bracket, knife pivot lifting and pressing down adjustment device.
? ◆It change the blades through moving out the bracket hydraulically and is very convenient and fast.
?

?
?
4. Scrap winder????????????????????????
? ◆It consists of base, the shaft and plate of scrap material, friction wheel, supporting wheel chain, chain, decelerator and moment motor.
? ◆It is used to pack and wind the slitting scrap strips.
?
5. Tension device
? ◆It consist of base, pre-dividing shaft, bracket, press shaft, hydraulic damp device and hydraulic shaft lifting the press down device.
?

?
?
6. Hydraulic recoiler???????????
? ◆It consist of base, bearing frame, recoiler shaft, the expansion device of hydraulic recoiling, the expanded recoiling plate, movable arm bearing, supporting decelerator, 30KW frequency conversion control motor.
? ◆It uses the hydraulic movable arm with the supporting spacers to ensure the even recoiling quality.
?
?

?
7. Hydraulic exit coil car??
? ◆The car can carry the dividing coils and lift up and down and is movable.
?

?
8. Electric control system: electric cabinet and operate table.???????
?
9. Hydraulic system: the hydraulic stand, pipes and the connect part.
?
?

Applications

?
ZJX-0.5-1.5X1250mm simple hydraulic slitting line is used for slitting the CR/HRC/stainless steel /galvanized to prepare for the next process.
?

?
Layout of the whole line

?
?
Below is the photos from our slitting line
?

?

?
?
Customer with manager

?
?
?
Competitive Ad