Powder Coating Oven , Non-standard Bridge Drying Tunnel

bridge drying tunnel powder coating line

1. drying tunnel designed for two-wire single-head (U) and out of the drying tunnel,

2. use diesel indirect heating.

3. Outer panel color steel plate, inner plate galvanized sheet.

?Powder Coating Oven , Non-standard Bridge Drying Tunnel

drying tunnel: (bridge style)

1.1 drying tunnel designed for two-wire single-head (U) and out of the drying tunnel, the use of diesel indirect heating.

1.2 drying tunnel puzzle structure, high-quality rock wool sandwich panels. Outer panel color steel plate, inner plate galvanized sheet.

1.3 using the following air, hot air circulation below the return air, hot air circulation using positive pressure air duct conveying the Supply Duct each outlet with wind control board, uniform temperature distribution in the drying tunnel. The drying tunnel thermal cycling fan with low ultrasonic, high temperature, Direct fan manufacturing.

1.4 fuel heating system consists of a combustion chamber, stainless steel heat exchanger, circulating fan, imported fuel burners, automatic temperature control probe, light diesel fuel burner in the combustion of the combustion chamber indirect transfer of heat through the heat exchanger drying tunnel internal cycle by circulating fan, so that the internal temperature of the drying tunnel rising to the set temperature distribution uniform. while ensuring the drying tunnel heat air clean and pollution. burner used Italy Riello burner, automatic control the temperature of the drying tunnel and digital temperature control, combustion exhaust gas through the exhaust pipe to exclude

1.5 hot air circulation fan cooled built-in, the circulating fan using a special high-temperature, low noise centrifugal fan, fan impeller, spindle and bearings are specially treated, noise <80dB.