Tough Stone Mosaic Tile Adhesive / Strong Adhesive Strength

PB-03 is a kind of high quality environment-friendly waterborne powder which can be mixed with water and used for bonding ceramic tile on the surfaces of wall, ground and floor. It is easily applied and can achieve an excellent adhesion.

Features:? ??

1, A new type strong stone adhesive, applied to all kinds of low water-absorption stone materials like large-sized artificial stones, culture stones, and natural stones.

2, No need to wet the brick wall, effectively improve the efficiency.

3, Strong bond ability, material-saving, much safer and firmer than the traditional cement adhesive, also can reduce the construct trash and the weight of the wall.

4, Good anti-acid, anti-alkali, anti-infiltration and anti-aging function.

5, Small shrinking rate, no cracking, can be used in cold and humid environment.

Application:

1, The adhesive for the cement plaster, brick and smooth cement surface.

2, The adhesive for low water-absorption surface and light weight board, like Eterpan, Pine Board and gypsum board.?

Surface Treatment:

The substrate surface should be firm, dry and clean, no grease, no wax, and other loose materials.

Operation Process:

1, The ratio: PB-03: water=3.3: 1 (20kg powder, about 6kg water) .Stirring them into paste, using an electric mixer to make uniform paste, put it aside for a few minutes and then a little stirring to gain the better effect.

2, Using tooth scraper to scrap the adhesive onto the surface evenly, control within 1㎡, then push the stone above it.

3, For the tile or stone material with deep ditch, not only scrape the surface, but also the backside of the tile or stone.??

Normal Amount:

Coverage areas differ according to the circumstance:

1, Using 3×3mm tooth scraper about 1.8kg/㎡;

2, Using 6×6mm tooth scraper about 3kg/㎡;

3, Using 10×10mm tooth scraper about 4.8kg/㎡;

Note: The amount is related to the smoothness, vertical rate, and thickness of the stone material.

Cautions:

1, Make sure the smooth and vertical rate of the surface before operation..

2, Never mix the dry slurry with water for second use.

3, Check the mortar layer of the back side, make sure that have no cavitation.

4, Can not be walked on or filled crack unless finished after 24h.

Store Method:

Store in cool and dry place, unopened product can be saved for one year.

Packing:

20kg/bag