Cloning /copy/duplicating RF Switch's Remote Control/original Remote Control 315MHZ433MHZ 433.92MHz

Product Description

      1. Working voltage:   DC12V 
        2. Working Current:     12MA
        3. Transmitting frequency:   266-433MHZ
         4. Transmitting distance:   200M 

    the 4 Channel RF Wireless Remote Control Duplicator for Cars, Garage Doors , Gates doors, Alarm systems etc. Fixed frequency (433.92mhz or 315mhz) for copying 99.99% common fixed and learning code remote controls.

Face to face copy the functions of your original remote by this 4-channel RF remote control duplicator with code learning functions and you'll always have a back up.

Duplicate Your Existing Remote Controllers: 

1.          Vehicle central locking systems  
2.          Garage  doors  
3.          Electronic  gates  
4.          Electrical  appliances  
5.          Car  sunroofs  
6.          Heating  systems

            Easy to install and use, the 4 channels remote control system lets you take control of your gadgets,  car and home or garage.

Works with the following remote control modules (please check your existing remote control before ordering): Your remotes also should be Fixed code or Learning code. 

•2260, 2262,  FP527, HT12D ,  HT12E ,  PT2240,   S026-1 ,S026-2 ,S026-3 ,S026-4, SMC918.... etc          

Please note that  it does not copy/cloning/duplicate rolling code

    Methods of operation

  1, Clear out code:

      Press A and B at the same time, two seconds later, LED  flashes three times, followed by a continuous fast blinking. Indicates that the remote control code stored was deleted.

       2, Duplicating (learning)

       Right Hands press original remote control A, and left hand press remote control duplicator A', 2 remote controls put together as close as possible, while pressing the remote controls two match button,(eg: A-A’,B-B’) three seconds later, LED indicator light flashes three times, followed by a continuous fast blinking. That's mean successfully copied.

        3, Recovery code

        Press A and C at same time , 3 seconds later, LED indicator light flashes three times, followed by a continuous fast blinking. This indicates that the original remote control codes have been restored.

The other way, you can delete all and relearn them again