UT-2177, Fiber Optic Transceivers, Single-mode 20km, 40km, 60km and SC, FC, ST Interface

UT-2177, Fiber Optic Transceivers, Single-mode 20km, 40km, 60km and SC, FC, ST Interface

Appearance Description
DIP Switch:
● When DIP switch 1 is set to “OFF”, switch and switch are not in operation mode. Switch 2 and 3 can only be configured when Switch 1 is set to “NO”.
● When DIP switch 2 is set to “OFF”, the electrical interface opearting rate is at 100M; when set to “NO”, the interface operating rate at 10M.
● When DIP switch 3 is set to “OFF”,the electrical interface is at full-duplex operation status; when set to “NO”,the interface is at semi-duplex operation status.
● When DIP switch 4 is set to “OFF”,LFP function is banned; when set to “NO”,
LFP alarm function is then activated. LFP function is used to detect the connection between optical and electrical interfaces. When remote optical or electrical interface is disconnected, it notifies and disconnect the corresponding local optical or electrical interface, and the indicator will be off. This helps technicians to quickly identify the point of connection error.

?

Side panel view

Support?the?IEEE802.3?Ethernet,?IEEE802.3?U?Ethernet?protocol?standard

1.?The?technical?parameters:

2.?Fiber?connection?parameters

①??Transmission?fiber?optic

Multi-mode:50/125,62.5/125,100/140μm

Single-mode:8.3/125,8.7/125,9/125,10/125μm

②??Transmission?Distance

Multi-mode:5km

Single-mode:20km,40km,60km,is?user?requires.

Connection?cable?UTP5:100m

Description:???

??? The 10/100M fiber optic transceiver is used for data communication between 100Base-TX twisted pair and 100Base-FX cable, or between 10Base-T twisted pair and 10Base-FL cable. It is the most