Jaw Crushing Machine (PEX Series)

Brand Name	DSMAC		Place of Origin	China
Model Number	PEX150×750, PEX250×750, PEX250×1000

Jaw Crushing Machine (PEX series)

Features of Jaw Crushing Machine:
1. Crushing cavity is deep without dead zone. It is easier to feed materials and yield higher output.
2. Jaw crusher is featured with high crushing ratio and sound epigranularity.
3. The gasket type adjusting device of the discharge gate is characterized by reliable performance, convenient use, large adjusting range, and improves the equipment flexibility.
4. The lubricating system is safe and reliable. It makes it easier to replace components and requires little maintenance.
5. Jaw crusher features simple structure, reliable performance and low operating cost.
6. It is highly energy saving. A single machine saves 15%~30% of energy consumed and the system can save over half the energy consumed.
7. To meet different client needs, the discharge gate is designed with a large adjusting range.
8. Jaw crusher causes low noise and creates little dust.

Application of Jaw Crushing Machine :
Jaw crusher is mainly applied in crushing multiple ores and large block materials into medium granularity, the materials’ compression strength not more than 320Mpa. Jaw crushers can be classified two kinds: PE series coarse jaw crusher and PEX fine jaw crusher. PE and PEX series jaw crushers have the complete specifications, and the feeding granularity of jaw crusher is 125mm-1020mm. They are the best choice for the primary crushing. Jaw crusher is also used in mine, metallurgy, building materials, road building, rail building, water conservancy, chemical industry and other industries.

Working principle of Jaw Crushing Machine :
This crusher adopts the electric motor as the power. The eccentric shaft is revolved by an electric motor through v-belts. It causes the swing jaw following the preconcerted path to crush the feeding material. Thus the material will be crushed in the crushing chamber which is composed of the stationary jaw plate, swing jaw plate and the liner plate. The material is discharged from the lower part of machine that is what you want.