safety harness

safety harness

Keywords: Safety Belt

Shanghai Penco Industrial Co.,  Ltd

Other keywords:    lineman safety belt, hanging safety belt, waist safety belt

1.Full Body Safety Belt, Safety Harness for Rescue Work

Full body harness is designed as body support primarily for fall arrest purposes, i.e.

a component of a fall arrest system and complies with EN361:2002. 

Full body harness TE5124A  Series is made of pieces of polyester webbing

which are sewn and connected by metal buckles.

This configuration guarantee full safety and comfort work.

2.BASIC EQUIPMENT:

* Back attaching buckle- for attaching fall arrest system;

* Connecting and adjusting buckle- for comfort wearing and using of harness.

3.ADMISSBLE TIME OF USE:

Full body harness can be used for 5 years counting from the date of putting the harness into operation.

After this period the harness must be withdrawn from use to carry out manufacturer's detailed inspection.

The manutacturer's inspection can be carried out by:

* manufacturer

* or person recommended by manufacturer

* or company recommended by manufacturer. 

After the inspection, the admissible time of harness use will be established until next schedule inspection.

4.HOW TO PUT ON THE HARNESS:

1.    Take the harness out from the packing, holding it by the dorsal tightening ring.

2.    Wear the harness by slipping on the shoulder straps one after one, taking care not twist them.

Adjust them by pulling or releasing the slack end, so that the buttock strap is firmly in place under the buttocks.

Pull one and the other thigh strap through the crotch and latch each strap. Make sure not to cross the straps.

3.    Attach the chest strap and adjust its tension to hold the shoulder straps centered on each shoulder.

Check that the belts would not be wrapped up themselves. 

4. Adjust the harness by pulling and releasing the free end of the belt,

so that the belts would be well tight and at the same time would not prevent free movements.

5. The adjustment should be effected by checking that the dorsal ring would be positioned

between the shoulder blades or frontal tightening connector would be positioned

at the height of the breastbone and that the sitting belt would be correctly positioned.

6. For the frontal tightening, the connector of the two back eyes should be in compliance with the norm EN362,

always connected to both eyes and locked. It is always recommended its use,

even if you are using the dorsal tightening ring.

Our Company