Olimy body kits from fiberglass car fiberglass car body

Mould treatment: 

Polish: Moulds must be polished before production. This will guarantee the good and solidified surface
Clean: Special detergent are used to get the dust away from the mould. This will make no dark markings in the gel coat surface. 
Release agent: This will be brushed on the mould to make demoulding easily.

Fiberglass and resin:

Gel coat: The color is decided by the gel coat,with thickness of about 0.3-0.5mm. UV resistant can be added. 

Surface mat:  This is to avoid the air bubble on the surface, and also make fiberglass mat  invisible from the finished surface. 

Fiberglass mat: Normally we use 300g/m2 (0.6mm thickness) and 450g/m2 (0.9mm thickness). Accordig to your requests on the thickness and strength,we will calculate how many layers of fiberglass mat should be used.

Demould and trim:

Solidify:  The time required for solidifying depends on thickness and weather condition.Normally 24 hours for one piece to solidify to avoid any deformation after demoulding. 

Demould: After solidified, the product will be demoulded

Cut and trim:  We will mark the trim line and hole positions on the mould,then trim according to the marks to gaurantee the mounting dimensions

Air bubble test and repair 

Air bubble test: Every piece will be put into the oven under 44 celsius degree for about 20 minutes,so that the air bubbles can break out then our workers will repair the surface. 

Repair and surface treatment: we will make the air bubble repaired and treat the surface with average gloss.

Packaging:  1.Air bubble packaging

                     2.Plywood Crate or shelf packaging

                     3.Carton packaging

We choose economical packaging on condition that there will be no damage during transportation.

Shipping: We are very glad to get the freight cost information for you as we have forwarders which have been cooperated for a long time.

1)  8 years' experience in fibrglass product trading, have good knowledge on process, quality control, request on different products, ready to offer international service for you. 

2)  Complete production line from fiberglass sheet to mould and finished products,which keeps a better quality control and will also save cost for you.

3)  Hydraulic Press Machines with capacity from 60 to 2000 tons, which enable us to make products with maximum projection area of 4 square meters, so that we can meet your different size requirements.

4)  150km away from Shanghai Port, which will shorten the delivery time and save freight cost for you.