Automatic cottonseed oil refining equipment made in China

Automatic cottonseed oil refining equipment made in China

Automatic Control System

Our company has applied the automatic control system with advancedness, security, reliability into the pretreatment, etraction, refining and fractionation in large oil plants. For its application in automatic control system, it can control the production in the entire workshop and monitor the operational status of each device by controlling the computer terminals in the room. One person only can operate the entire workshop, with efficient production management. It has reduced the production cost greatly and improved the management efficiency.

Automatic cottonseed oil refining equipment Introduction:

Alkali hot water

Crude oil filter reactor reactor centrifugal separationoil residue

Phosphoric acid hot water

Degumming oil cooler dry centrifuge separation alkali liquor

vacuum steam jet pumpsteam citric acid

bleaching earth decoloring filter decoloring oil heat

 refined oilfiltercooldeodorizingvacuum

Automatic cottonseed oil refining equipment -Main Processes Introduction

Automatic cottonseed oil refining equipment

Neutralization: the crude oil is output by the oil feed pump from the oil tank, and net enters the crude oil heat echanger to recover part of heat after metering and then is heated to the required temperature by the heater. After that, the oil is mied with the metered phosphoric acid or citric acid from phosphate tank in the gas miture (M401), and then enters the conditioning tank (R401) to make the non-hydratable phospholipids in oil change into the hydratable phospholipids. Add the alkali for neutralization, and the alkali quantity and alkali solution concentration depend on the quality of the crude oil. Through the heater, the neutralized oil is heated to the temperature (90C) suitable for centrifugal separation to remove the phospholipids, FFA and other impurities in the crude oil. Then the oil goes to the washing process.

Washing: there is still about 500ppm soap in the neutralized oil from the separator. To remove the remaining soap, add into the oil about 5~8% hot water, with water temperature 3~5 C higher than the oil generally. To achieve more stable washing effect, add phosphoric acid or citric acid when washing. The re-mied oil and water in the mier is heated to 90-95C by the heater, and then enters the wash separator to separate the remaining soap and most water. The water with soap and oil enters into oil separator to separate out oil in the water. Further catch the oil outside, and the waste water is discharged to the sewage treatment station.

Vacuum drying stage: there is still moisture in the oil from the wash separator, and the moisture will affect the stability of the oil. So the oil at 90C should be sent to vacuum drier to remove the moisture, and then the dehydrated oil goes to the decoloring process. Finally, pump out the dry oil by canned pump.

Decoloring Process:

The main function of decoloring process is to remove oil pigment, residual soap grain and metal ions. Under negative pressure, the mechanical miing method combined with steam miing will improve the decoloring effect.

Picture of Automatic cottonseed oil refining equipment

If you have interest in our Automatic cottonseed oil refining equipment,just free to contact us.