automatic hand operated oil expeller

automatic hand operated oil expeller

Introduction of automatic oil press machine

The hydraulic oil press machine has widely application,which is capable of processing a great number of seeds and nuts,such as cotton seeds,suflower seeds,grain seeds,hemp seeds,peanuts,soybean,corn germ,palm kernel etc more than 30 kinds had been tested.

Working principle for palm oil mill

1>before each extract oil preheating, preheating temperature: summer, autumn and 50 degrees -70 degrees, winter and spring of 70 degrees -90 degrees warm-up system of automatic control, without shutting down the temperature control switch.

2>Hold the wrench handle on the roof fully open: the roof and working position of 180 degrees, to the bottom of the pad pressing tang good cushion, the Pistons fell into place and set aside.

3>each crushing empty before running 1-2 times, such as winter and spring, hydraulic oil tone, empty machine should run for 5-10 minutes, the oil thinning, easy to operate.

4, the oil has been fried, drained smoke, loaded squeeze tang.

5, at the upper end of the oil squeezed tang good cushion pad, the separator plate pressing on the tang end face of a plug into the juice tang. If less oil, the oil can be increased at boot time, so keep the oil at the end face on a plane slightly lower than virgin Tang; otherwise, do not join the upper Han plate, lift the manual valve handle, turn the press.

The parameter for palm oil mill