1-2.5mm Steel Wire Straightening And Cutting Machine

1-2.5mm steel wire straightening and cutting machine

Introduction and Features of 1-2.5mm steel wire straightening and cutting machine

1.It's suitable for wire, stainless steel wire, galvanized wire, aluminum, water (powder) draw lines and other metal wire straightening and cutting.

2.To straighten party lines, flat lines, contour lines, please contact the company ordered.

3.Sending wire wheel, such as the use of high-quality steel cutter and vacuum heat treatment, wear resistance, longer life. Straightening block can be cast iron, alloys, plastics Wang, all shaft parts are all 40CR or 45 # steel, and after straightening process, the gear is used in all forging billet, straight and tooth surface by high frequency hardening, hardness up HRC55-58 degrees.

4.Straight shaft with high pressure wheel straight before cutting the wire straightening, wire feeding pressing the pinch roller lever to adjust wire feed, the wire can even feed, direct modulation axis is the key product formed by direct modulation straightening blocks and tone straight shaft fixed to adjust the horizontal and vertical products to conform to requirements. Adjusting the pressing handle, the wire and the wire is more horizontal and vertical production rate increase or decrease. Finally, adjust white blades gun on the length of the product to meet the requirements.

Technical Parameter of 1-2.5mm steel wire straightening and cutting machine

Main parts of 1-2.5mm steel wire straightening and cutting machine

5-9mm steel wire straightening and cutting machine with gun

5-9mm wire straightening machine without cutting gun

 2.Raw wire frame:

3.Pulley adjustment handle, ready to tighten the belt, effectively preventing the belt after a long time with work loose.

About sending wire wheel adjustment handle, before and after the two groups, with the handle to adjust the lateral position of the wire to the wire spool living adjustment and the positioning hole cutting gun hole in the center position.

4.Sending wire wheel pressure regulating handle, a total of around two, use this handle to adjust wire feed speed. 

 5.Fast inverted switch, allowing the operator reliable and convenient.

 6.Wire hole filling box, which fill cotton, plus lubricating oil, allowing straightening process more smooth, reduce breakage.

 7.Six groups of straight blocks kinds of materials can be easily transferred straight wire, easy to use, easy to operate.

Maintenance:

First, the machine used for the 3-phase 380-volt power supply, do not want to phase, such as phase, then definitely burn out the motor.

Second, the transfer of parts of the machine periodically lubricated.

Third, when installing reliable grounding.

Fourth, the work machine cover must not be opened, otherwise accidents can easily occur in the event of disconnection, this operating essentials please remember! ! !

Fifth, the tip portion of the wall please, in order to avoid stab workshop run line when other staff.

Sixth, when a roll of wire will transfer finished, please stopped three times during the rest of the machine, otherwise the remaining thread parts may produce drift phenomenon, it is easy to hurt workers in the operation. If you think the wire waves get serious, experienced workers can use pliers sandwiched thread push, but we do not encourage this mode of operation.

For 2.5-5.5mm wire straightening and cutting machine,pls click the following photos: