Sensor electric automatic toilet seat

Main Function:
1. Replacement Warming:
A red line will appear when the seat cover remains 2-3 m. It reminds you to replace the seat cover.
2. Seat:
Somatological fit, fully comfortable, 67mm in width.
3. Power Supply:
A. Rechargeable battery
B. AC/DC adapter, the extensive application scope of AC/DC power voltage (100v-240v).
4. Charge (Tow Ways):
A. the power supply is available around the toilet:
- Open the white cover located on the back of pedestal and have it charged.
B. the power supply is not available around the toilet:
- Push the lever on the bottom of left side, then, take out the seat and have it charge where power supply is available
- Open the cover located on the back of pedestal, pull the red ribbon and take out the battery, then have the battery recharged where power supply is available.
5. Microcomputer & Indication Light:
A. Overload warming signal: LED light will stay on for 2 seconds.
B. If no loading or counter wheel fault for the film roller or is not installed in place signal: LED light is on all the time.
C. The LED will flash when battery is in low voltage.
D. Restarting interval (5 seconds) to avoid waste.
6. KWS-B1 Button
7. KWS-B3 Point Color Light Button
8. KWS-B2 Ring Color Light Button
-
Specification:
Material: ABS
Service Time : Five year above
Power Supply:
Recharge Battery or By AC/DC Adapt directly
Adapt Input Voltage: AC 100-240V
Output Voltage: DC 7.2-6V
Charge Output Voltage: DC 6V
-