Copper Cathode Production Line Automatic Stripping Machine Peeling Machine

Copper Cathode Production Line Automatic Stripping Machine Peeling Machine   

1. Functional Description

    Copper is deposited electrolytically onto blank cathodes in electrowinning cells located in the tank house. Loaded cathodes are periodically removed by an overhead crane with lifting bale and delivered to the cathode stripping machine. The cathodes hang vertically from the bale and are deposited on the receiving station of the machine. While on the receiving conveyor, the loaded cathodes are cleaned with high pressure and temperature water spays to thorough wash all surface. After passing through the wash booth, the loaded cathodes are transferred from the receiving conveyor to the stripping station to remove the copper. The stripped cathodes are transferred to a reject conveyor, and damaged or non-stripped cathodes are transferred to the discharge conveyor. Stripped copper is sampled, weighed, bundled, strapped, labeled and removed by forklift. 

 2. Structure

v

3. Parameters and Requirements(Designed as per buyer)

1) Design capacity: 200 cathodes per hour

2) Noise level: 80dB dB (A) at most within 1 meter from motor and pump, but the stripping zone sometimes higher

3) Washing effect: deposited copper surface clean, no electrolysis residue, no copper sulfate crystals, no other attachments. Wash water temperature ≤ 70 °C

4) The amount of washing water cycle: 1 circulating pump, a heat sink of 12m3, 50m3 / h,  cycle of changing the water is 1 day

5) Dimensions: length × width × height: about 11000 × 12000 × 6700mm (can be adjusted according to the site)

6) Total weight of approximately 54 tons

7) Stacking number: Standard 10-26 block / stack (installed counter, set free), or the total thickness ≤ 700mm;

8) Power requirements

Power requirements: 380/220V, 50Hz;

Control Power: 24VDC (buttons, lights, hydraulic solenoid valve control power supply, etc.);

The total installed power: 130 kW (need to be finalized after the basic design of the device);

9) Steam supply: 2200kg / h, 143.6 °C ,0.3-0 .6 Mpa

10) Fogging fan: about 5000m3 / h

11) Hydraulic system

 Operating pressure: 8-12Mpa

 Hydraulic unit cooling water

 - pressure   0.1-0.15Mpa

 - Temperature  ≤32°C

 - Flow rate  About 110L/min

 -Hydraulic oil  ISOVG46 anti-wear hydraulic oil

4.The work flowsheet: