Air Flow Biomass Charcoal Carbonization Furnace

The information of the Biomass charcoal carbonization furnace  

The  Biomass charcoal carbonization furnace  for briquette charcoal is used to make the charcoals by dry installation and mositure removement in the oxygen free atomosphere.

The principle of the Biomass charcoal carbonization furnace   

The Biomass charcoal carbonization furnace uses the high temperature and dry carbonization process to make charcoals. Its equipment use high temperature cooling system to cool the charcoals products so less cooling time will be needed.

The feature of the Biomass charcoal carbonization furnace

I: smokeless: the gas which produce in the carbonization process would be reuse by the Biomass charcoal carbonization furnace . The little water vapor would be come out into the atomosphere.

II:easy to operate. You only need one person to make charcoals. That will help you save your workers.

Materials to make charcoals for the Biomass charcoal carbonization furnace

The final products to make charcoals for the Biomass charcoal carbonization furnace

The process of the Biomass charcoal carbonization furnace

I: heating process

at first, hard fire are used to improve the temprature of the  Biomass charcoal carbonization furnace . After half an hour, you should use one line fire to remove the moisture of the materials.

II:pyrolyse and dry distillation the materials.

After the moisture are almost removed, the process is a chemical action to make charcoal by pyrolyse and distillation process. In this process, the wood tar would be produced. My factory design a purification tank to collect the wood tar.

III: the cooling process

When there are almost no smoke appears in th process, the carbonization process are ended.Hang the inner port out and seal the pipes of the cover.

Let is cooling by wind or naturally or water. When the temperature comes to 50 centi degree, you can make the charcoals out from the inner port.

The components of the Biomass charcoal carbonization furnace

I: inner port

This part include inner tank and sealed top libs. they are made of wear resistence materials. The three steel baskets are packed together. It would be easy to ship.

II: outer port

The heating room are used to heat the stove.

The furnace body are made of good quality bricks.

The heat keeping layer is heating insulting materials to keep heat.

III: purification tank

The purification tank and exhausted-gas recycling pipe are contained.It is used to purify the smoke by cooling scream technique and filter the wood tar. The smoke after the purification tank would be water vapore to the aire and no polution to the environment.

IV:smoke recycling tube

During the process of carbonization, there would be some combustible smoke appears.Then the smoke will go back to the furnace by the purifying tube.After purifying, the smoke will return to the outer stove to reheat.

VI:the hoisting equipment

It includes the steel hoist frame and Electric Hoist. It is easy for you to load the hot inner port out of the furnace to prohibide the burning accident in the whole process. and that only need one person to work. That will save your worker and your investment. my telephone+8615639726535

If you have any questions about the furnace, contact me at any time.Here is my bussiness card.

Biomass charcoal carbonization furnace