laser hair removal machine new products looking for distributor

wooden box,aluminum box,paper box,

2015 laser hair removal machine new products looking for distributor   

 1. Features

   1.  Treatment handle using sapphire optical crystal as light guide, never worn, life-long use without replacement.

   2.  Semiconductor refrigeration, air cooling, closed loop force strong temperature water cooling system, make sure long time continuous work. The water flow sensor and water temperature sensor, effect cooling system, greatly increase the life of the machine and the safety facto

   3. Treatment time is short, quick recovery, do not effect patient's normal work

   4. Skin test function: Using adjustable high-powered video camera , can see clear treatment effect before and after treatment, and stored by the file management system.

2.  Application

   Permanent Hair removal of all body part : beard, lips,arm ,leg ,armpit hair,bikini line and so on

Improve pigment ,dark color of the mole ,burgundy birthmarks and other symptoms

                                                  System working conditions

   1. Temperature of environment :5~40℃

   2. Relative Humidity:≤80%

   3. Power supply:Single-phase AVC 220V,110V ±10%  10A  50/60Hz

    Along with the machine main body , there is one input power plug, as the standard single-phase three-pin plugs (international standard plug for power network connection)

3. Installation

   Open the package, and check all the accessories first as the Accessories List , to make sure all the accessories are in good condition

Water to the apparatus :

       1:One time you need to enter 8L cooling water, the water must be distilled water, so that keep the laser generator not burn and long life. Damage caused by the not distilled water, our company can not warranty.

       2:For the first time , when the water enough to " high water level", stop inject water, turn on the machine working 3 to 5 minutes to let the water cycle in the machine, emptying the gas in water cycle pipe. Then turn off the machine and inject water again till to the " high water level" 

Installation and disassembly of diode laser treatment handle:

Note:

1,You must turn off the machine when you do the above installation and disassembly of the handle

2, After change the handle,while inject cool water, you need to pay attention to the handle connectors, if there are water leak, please drain all water first, disassembly handle, and keep connectors on handle and machine dry,and install again and then inject distilled water again. 

3,If do not use this machine for long time or need to transport, please make sure drain all the water.  

4,Change water: every month you need to change the used distilled water with new distilled water

5,Before put the handle back to the holder, you must make sure the handle switch button is on "OFF" station , there are no light produced by the laser generator . (For fear of damage the holder and machine inner electric boards )

 System parameters

1. Treatment room must have a stable and reliable power supply system with ground protection
2. Adapted voltage range : 200V - 240V  or  100V-120V

      If your local voltage beyond this range , we recommend you add a regulator, and the regulator's power should be greater than 3 KVA.

      3. Cleaning of treatment head

Every time finish treatment, you need to clean the treatment handle, especially the crystal light guide . You can use gauze or a cotton swab dipped in 75% alcohol wipe the crystal 3 to 5 times .

Please feel free to contact us