High Quality Quartzite Tools Sterilizer

Introduction:                                                            

This autoclave sterilization machine uses steam to sterilize tools especially small tools like scissors, nippers, clamps, nail sets and other objects. This means that all bacteria, viruses, fungi, and spores that can be quite resistant are inactivated. Autoclaves commonly use steam heated to 121–134 °C (250–273 °F). To achieve sterility, a holding time of at least 15 minutes at 121 °C (250 °F) or 3 minutes at 134 °C (273 °F) is required (MAX 250°C in this autoclave sterilization machine).

This autoclave sterilization machine removes any bacteria, viruses, fungi or spores on tools with max temperature up to 250°C.

Features:                                                                          

·CE Approved to provide you with Safe and Reassuring Sterilization

·100% completely sterilize and kill ALL microorganisms for all types of instruments and materials (except plastic/flammable/explosive substances): solid, hollow, porous, wrapped or unwrapped.

  Much more effective than UV sterilizers

·316L type stainless steel chamber and door with electro-polish finish

· time and temperature controller, adjust accordingly.

·Ideal sterilization solution for any medical, dental or healthcare environment where speed and flexibility are required without compromising quality

·Adjustable Timer to Assure Different Needs for Sterilizing

·Great for Both Commercial or Family Use

·No Assembly Required
How to Use:                                                            

1. Put the tool sterilizer in a stable surface.

2. Open the lid, pour quartzite into the pot; quartzite can not be too much(not beyond 80%of the inside capacity).

3. Connect the power,and turn on the switch ,the light turn red and the product begin to heat at the same time.    

4. After 12- 18 min heater, insert the tools(scissors, razors, nail cutter, etc) into quartz sand vertically.

5. Wait for 20--30 seconds, put on the adiabatic gloves and take out the sterilized tools.

6. When the inside tank reach the setting temperature, the light will be automatically off and the sterilizer stop heating;

7. And the sterilizer will heat automatically when the temperature is lower than 135 degree, indicator light will turn on again.

Attention:                                                                     

1. Do not plug on before identifying the voltages of product and electrical source are congruent.
2. Ensure that the power supply is with good grounding. 
3. Place the product on a stable aclinic table.

4. Do not let children touch the product when working.

5. Never use the product when there is no quartz sand in the tank.
6. No touching the fuselage with bare hands, avoiding any scalds.
7. Keep quartz sands filling no more than 80% volume of tank, in order to prevent overflow when inserting tools

into quartz sands.

8. After disinfecting, it is necessary to turn off the power switch and wear gloves before take the tools out. 
9. Please turn off the power switch when finish using. Remember to plug out if don’t use of the product in a short time.

10. Cleaning should be done after the product is plugged out and cool down.
11. Never clean the product by water or other liquids directly.

0°C to 250°C adjustable

120 minutes