Multi polar rf with photon lights cool tech fat freezing machine for weight loss slimming

1. Principle

Cryotherapy technology refers to the treatment gradually reducing the subcutaneous fat. The fat cells are cooled down to zero degree and become solid. The low temperature selectively damage fat cells while leaving skin or muscle intact. The dead fat cells then are excreted through the liver.

2. Technical background

Liposuction is a cosmetic surgery procedure to remove excess fat deposits, realizing localized bodily sculpting and helping people to get slim. Usually the procedure is done with special surgical instruments in plastic surgery or dermatology. It is an invasive way to remove the subcutaneous adipose tissue.

Other non-invasive methods, such as weight-loss drugs, diet, regular exercise, diet control, or combination of these methods, whose shortcomings may be invalid, even infeasible in some cases. For example, when people get physical injury or ill, they can not choose the method of regular exercise. Similarly, people cannot choose the weight-loss pills or topical drugs when they are allergic to them. In addition, physical or systematic weight-loss method can not eliminate the fat at specified location.

Cryotherapy technology is fundamentally different from other non- or minimally invasive methods, it is approved as the most effective way to reduce fat.

After being put into use, this revolutionary new method has been recognized as an important technical advance in fat reduction. For those who control diet and exercise regularly but still need to eliminate localized fat, cryotherapy is a great gift. It can produce amazing results for reducing fat at waist (love handles), back, hips, belly and thighs.

Under the condition of low temperature, triglycerides (fat) will be transformed into solid. The machine uses advanced freezing technology, which targets at fat bulge selectively and eliminates fat cells through a gradual process. It has no harm to the surrounding tissue, but only reduces the excess fat. After fat cells are killed, they are gradually eliminated from the body due to normal metabolism; the thickness of fat layer will be reduced gradually, so as to achieve the removal of excess fat.

             Middle cryo handle:

                                   Size: 155 MM

3. Preparation before use

Install the 4 attached caster wheels on the machine, fasten the screws.
Install the attached on-hook on the machine, put the probes into the corresponding racks.

Before using the Cryotherapy Slimming Machine, it is required to open the inlet and overflow behind for adding distilled water or purified water.
Connect the attached water funnel to the inlet, start adding purified water until water flows out from the overflow, and then close the inlet and overflow.
Check the host power cable is connected.
Check the key switch of machine is connected.

4. Treatment settings

30 – 60 minutes to each part (depends on the thickness of localizedfat)

You can only treat part by part, for example, to dissolve fat of the entire waist you need complete several courses. Please do not treat more than two parts of body in the same course of treatment.Take another cooling procedure at the same position 2 months after the first course, which can reduce the extra fat layer thickness.

Ideal candidates for the Cooling procedure are relatively fit, but have some modest-size fat bulges that are not easily reduced through diet and exercise. They are seeking spot reduction for specific areas of fat, but are not considering a surgical procedure. The Cool Sculpt procedure is not intended for weight loss or obesity, and it is not a substitute for invasive methods such as liposuction.

5. Proposed use of clinical parameters:

P1:5 oC~ 0oC (default 30 min) – is recommended for treatment part with less fat.
P2: 0oC~ -2 oC (default 30 min) – is recommended for treatment part with moderate fat.
P3:-2 oC~ -5 oC(prednastavené 30 min) – is recommended for treatment part with much fat.