electronic device 2 in 1 facial&hair steamer

electronic device 2 in 1 facial&hair steamer 

888A is NEW PRODUCT.
Description :ozone inoic 2 in 1 hot hair and facial steamer

Function :
*creating lons and OZONE
* lons saturate hair and lock in moisture
* protect the hair quality and remove dandruff
* skin sterilizing and whitening
* with aromatic
Input Voltage :AC100V~120V ; AC 200V~240V (Valaible upon request)
Power :750W
Frequency :50Hz~60Hz 

1.Introduction
Features of this device
Durability is emphasized:
A:Stainless steel heating pipe is used.
B.Internal hot water cup is made with imported PC material.
C.European water level detection method is used to switch off power automatically when no water is available.

2.Setting before use
a.Place the five legs into their positions respectively.Put the lifting rod into the center hole od the leg support.Use a nut to compress the circular presser tightly against the lifting rod.
b.Place the machine onto the support stably.Secure the hot water cup at place.ture it as clockwise direct.
c.Install a spraying to be or a oiling hood accroding to your need.
1)How to install the steam hood:parallel inserts in place on the machine hole,fixed and tighten screw.
2)How to install the spraying tube:inserts in place on the machine hole.turn clockwise to tighten.

3.Main technical index
Rated voltage:220v-/50hz
Rated power:750w

4.Hoe to use the unit
1)Tighten the water cup in place
2)Add water from the water filler but do not exceed the MAX line.
3)connect to the power supply.Rotate the spray head to a comfortable angle.
Press the hot steam ON button
After about 4-5 minutes the water boiled then become steaming.

5.Safety function
The 2 in 1 facial&hair steamer is with good safety function.when the water level is too high or too dirty,it will automatically stop working and start beeping.After reducing or replacing clean water,you should restart the unit for reworking.
you won't worry about too much hot water spit out causing injury or too little water which damages the unit.
(Please kindly note the spray time and distance are judged by the skin type)

6.Attention for repairs
This device has been tested and examined strictly before leaving the factory.
in case any fault occurs during its operation,please send the device for repairs to our company's distributors or special repair shops in different places.
Non-professionals shall not disassemble the device.

Packaging&shipping
1pc in a corton
Meas:83.5*44.5*33cm
G.W:11kgs,N.W:9kgs