T8 1200mm led tube lighting with Stater

Specifications

T8 LED Tube Light 1200mm

Parameters:

1. Power: 18w

2. Voltage: 85~265v

3. Lumens: 1600lm

4. LED Chip: 3014SMD ( Epistar)

5. LED Qty: 168pcs

6. CRI> 80

7. PF> 0.9

8. CE Rohs

9. 3years warranty

 Features:                                                                                                    

• 80% energy saving than normal fluorescent tube
• Can be directly placed in normal T8 or T9 fluorescent brackets
• Solid state ,Without RF interference, Easy installation ,
• Lifespan: 50, 000 hours
• Low power consumption, high intensity

LED 8W equal conventional Fluorescent 20W.

LED 15W equal conventional Fluorescent 40W.

LED 25W equal conventional Fluorescent 60W.

Advantage :

1.Environmental

The conventional fluorescent lamp contains lots of mercury steam. If the lamp was broken, mercury steam will be volatized to the atmosphere, But LED fluorescent ldoes not use mercury, and the LED products also do not contain lead, playing an environmental protection role.

2.Seldom heat generation

Conventional  lamp generate lots of heat while LED lamp can converts all the elect energy into light and have no side-effect to the documents and clothes .

3.No ballast or starter

The LED lamp can be directly connected to power,  needing no ballast or starter, replacement  for conventional fluorescent lamps.

4.No flashing

Conventional fluorescent lamp used alternating current. Therefore, every second may cause 100-120 times' flash , but LED Lamp directly change AC into DC not causing any flash and can protect our eyes.

5.Free from mosquitoes'trouble

Different to the conventional lamp , LED Lamp does not emit ultraviolet ray, which can not attrat mosquitoes around the lamp .It will creates a clean and tidy living room

6.Power-saving and long life

The power consumption of LED fluorescent is 1/3 less than that of the conventional lamp. Lifespan is also 10 times(50000h) than the conventional lamp .Can be used for long time and do not need to replace, which can cut down cost. It is more suitable to difficult change occasions.

7.Installation diagram

 Can be directly placed in conventional T8/T10 fluorescent bracket, firstly remove the conventional fluorescent lamp, take out the starter and ballast or shoting the ballast connect lines, and then put on the LED fluorescent lamp.

8.Application

Widely used in Residential/Institution buildings, Hospital, Hotel, Factory, School, Supermarket, Meeting room ,Trains,supermakrt etc.