PERMANENT MAGNETIC PLATE LIFTER

Specifications

MAGNET LIFTER

The quick, safe and easy way to lift ferrous materials and work pieces.

These are two Pole Permanent Magnetic Lifters. The two poles are at the bottom of the lifter.

These lifters use high grade Magnets for producing strong magnetic flux path through the two poles.

The lifter is placed on the MS flat/block that is to be lifted. The turn of the handle in its ON position with MS flat/block/cylinders (to be lifted) at the bottom ensures completion of magnetic flux path through the MS body.

The MS body gets attached to the lifter. The turn of the handle in its OFF position detaches the MS body from the magnetic lifter.

Permanent lifter is made up of two parts, such as permanent sucker and discharge device.

The permanent sucker is made up of permanent magnet and magnet-conductive plate.

The magnetic force wire generated by the permanent magnet will go through the magnet-conductive plate, attracted materials and form a closed circuit thus to achieve the purpose of lifting the steel materials.

It is suitable for being used to lift and transport magnet-conductive billets, plates and rounds in industries of mechanical engineering, metallurgy, shipyard, car factory, dock and etc.

Attach the permanent magnet lifter to suitably tested lifting equipment, using the body hook.

To attach the permanent magnet lifter to the item being lifting, simply offer the base of the unit up to a clean, grease free on the item.

Determine the load weight and centre of gravity as accurately as possible. Once in position, move the magnet level fully anticlockwise until it is held captive by the level lock. Once attached, rise and move the item to where it is required. Before lifting/moving, ensure the load is free and not restrained by fixings etc. Lift the load a nominal distance to check balance and security of the load. Use tag lines to control long or bulky load.

Specifications