2015 New design 12W COB recessed LED downlight with lens SL100-012 ( Cutout 100mm, SAA, C-TICK certified )

Trim                                     Aluminum alloy

Trim Finish                           White

Heat Sink                             Aluminum extrusion

Beam Angle                         30°

Light Source                       Sharp

Input Voltage                       220-240V AC, 50-60Hz ( non dimmable, come with Philips driver )

       200-245 V AC, 50-60Hz ( leading edge, trailing edge and universal dimming )

PF                                         >0.9

Input Power                         12 W (nominal)

LED Output Power               10W (nominal)

Luminous Flux                     960lm(5000K), 948lm(4000K), 937lm(3000K)

System Efficiency (lm/W)     80 (5000K),79 (4000K), 78 (3000K)

LED working Voltage           36V DC (nominal)

LED working Current           240mA DC (constant current)

CRI                                       80+

Operating Temp. Range       -20 to +40 ℃

IP Rating                               IP20,Indoor use only

Storage conditions               Cool and dry place.

Driver                                     Exterior                                                  

Maintenance Of Lumens     40,000 hours at 25 ℃

Quality warranty                     5years ( With Philips driver )

Features:

Popular design, deep recessed with lens! Hot product!!! No adjustable

1)Model: SL090-012

2)Power:12W ( SHARP COB LED INSIDE)

3)Size: embedded installation 90mm(φ100 x 90 mm)

4)Input Voltage: AC200-265V( dimmable driver), AC100-265V (non dimmable driver)

5)CRI: 85 6)Color Temperature: 2700K-5000K

7)Lumen output: 960Lm

8) Packing: 20pcs in one carton, GW: 12KG

9)Lifespan:>50,000hours

LED Downlight Instructions

Thank you for purchasing your new LED downlight!

Please take the time to read and understand the instruction sheet below. Failure to do so may void warranty.

Safety Instructions:

All electrical installations must be carried out by a qualified electrical contractor.

Ensure all mains power is off before commencing any electrical installations.

This product is NOT suitable for damp or explosive environments.

Modification to any part of this product will void warranty.

How to install:

The LED downlight shall be installed in accordance with local electrical standards.

The LED downlight shall be installed in locations and in conditions as described in Figure 1 and Table 1.

Please make sure all electricity is switched of at the main switch board before any electrical works are to commence.

Cut out the hole according to the downlight's specifications.

The LED driver is supplied with an approved flex and plug.

For easy maintenance the use of plug base sockets in the ceiling is recommended.

If you are wanting to hard wire the LED drivers, please remove the supplied flex and plug from the LED driver.

When connecting the LED downlight to the LED driver, please ensure the connecting plug is securely pushed in and the connection is not loose.

Important note: never attempt to connect the LED downlight whilst the LED driver is on/live. Doing so will cause irreparable damage to the LED.

Install the fitting into the ceiling making sure the fitting is securely located.