24V 10A Solar panel controller with LCD screen

These series controllers are suitable for 12V/24V lead-acid battery system, if you need other types of batteries, please feel free to contact with the manufacturer or agents to customize.

Product Overview

1. Use single-chip microcomputer control which makes the controller has the advantages of intelligent, strong adaptability, reliable function.

2. Use PWM charge mode, which can improve system efficiency and prolong the life span of the battery.

3.Clear charge state, discharge state and battery power display.

4. Adopts the modified shell which accords with air flow, has better cooling effect (compare with the old version).

5. Optimize the assembly design, the structure more stable (new shell use 4 screws, old version use 2 screws)

Function

Installation Instructions

Open the top cover of controller and connect the wire with terminals as the diagram on the top cover of it.

Please first connect the battery, and then connect the solar panel and the load in order.

The controller has reverse polarity protection internally, but if the connection error still may damage your controller.

Please make sure the voltage and current are within the rated range of controller.

LCD displays the battery voltage, the charge and discharge status                         Failure interface

Charge: the left arrow display, when the left arrow flickers, it means the solar panel is charging, the battery is in the state of full charge or float charge.

Discharge: when the load output switch is ON, the right arrow display, it is allowed to discharge. When the controller has discharge current, the right arrow flickers.

Failure interface: when short circuit or over load occurs, the failure interface appears. At this time, you can press the load output switch to close the output or just wait. After finish trouble shooting, the output recovers automatically. If short circuit lasts over 30s, the controller automatically close the output.

Load output switch: the output switch default open, when the interface appears LOAD or the right arrow, the load output of the controller is permitted. When the battery is under voltage, the output stop, the output switch could not work. Only when the battery voltage returns to Normal, the output switch can be operated.

Troubleshooting

When the following phenomenon happens, please check as follows,

DOXIN is a professional manufacture specialized in  electronics and solar products  

We produce electronics products  more than 10 years .We have professional devel-

opment team.We pursues to establish the culture of "quality first ,reputation best ".

Our products usually are exported big quantity in to Europe, USA,African, Russia, Australiaetc. and our power inverter serials enjoy better reputation .With reliable

quality and stable performance.