Home > Products > Enviromental Testers > HOT SALE ! TN2365 The Taine UV irradiation meter(UV intensity meter)Ultraviolet radiation meter
HOT SALE ! TN2365 The Taine UV irradiation meter(UV intensity meter)Ultraviolet radiation meter
USD $450 - $500
/ Piece
1 Piece(Min.Order)
- 1000 Piece / Pieces per Month
- SHENZHEN
- T/T Credit Card PayPal
You May Like
-
HOT SALE !TN-2254 UVCUV irradiation as measured UV intensity meter
-
HOT SALE !TN-2234 UVA + UVB ultraviolet radiation meter
-
HOT SALE !TN-2700 humidity tester moisture meter
-
HOT SALE !TN-2300 Water Quality Tester
-
Air flow meter wind speed Range (Air Velocity) : 0.4~35m/s Anemometer TN2426
-
DT-620 Anemometer with Infrared Thermometer
Product Details
| Place of Origin | Guangdong, China | Brand Name | Graigar | |
| Model Number | tn2365 |
Product Description
HOT SALE ! TN2365 The Taine UV irradiation meter(UV intensity meter)Ultraviolet radiation meter
PRODUCT DESCRIPTION
TN-2365 UVAUV tester
1. Feature
-.365nmWavelength UV measurements
-.Professional, high qualityUVTable
-.Wide range:199uW/cm2,1.99mW/cm2,19.9mW/cm2
-.Micrputer circuit with high precision, multi-function
-.With a correction filter dedicatedUVProbe
-.LargeLCDDisplay, easy to read
-.Shell rugged
-.Maximum/Minimum records
-.Data Hold
-.Automatic shutdown
-.9VBattery
-.Button to zero
2. Specification
2-1 General Specifications
1. Feature
-.365nmWavelength UV measurements
-.Professional, high qualityUVTable
-.Wide range:199uW/cm2,1.99mW/cm2,19.9mW/cm2
-.Micrputer circuit with high precision, multi-function
-.With a correction filter dedicatedUVProbe
-.LargeLCDDisplay, easy to read
-.Shell rugged
-.Maximum/Minimum records
-.Data Hold
-.Automatic shutdown
-.9VBattery
-.Button to zero
2. Specification
2-1 General Specifications
3. Panel description
4. Measurement procedures
1) Press“Power”Button to turn on the power
2) Press“Range”Key to select the maximum range
*If the“----”, Out of range, select a similar high range.
3) Zero steps
The range to be set“199u W/cm2”
*The front of the probe Left-hand to a table or other flat surface, so that the back of upward.
*Press the zero key, the display value is zero.
4) ToUVThe probe is placed directly on the light source,LCDShown on the isUVValue.
5) Data Hold
*In the measurement process, click“Hold”Key, the reading will be locked at the same timeLCDShow“D.H”Symbol
*Click“Hold”Button to cancel data hold function.
6) Data record (maximum/Minimum value)
*Data logging function shows a maximum/Minimum reading. Click“Record”Key to begin data recording.LCDShow“REC”Symbols.
*When the“REC”Symbol is displayed when
a) Click“Recall”Key,“Max”Symbols and the maximum reading will be displayed inLCDOn.
b) Click“Recall”Key,“Min”Symbols and minimum readings will be displayed inLCDOn.
c) Click“Recall”Key to return to the data recording function, the relevant symbol disappears.
5. Measurement Considerations
*BecauseUVProbe the structural constraints, the output value of the probe may be about a year later1%Deviation, which is normal. Probe calibration cycle of one year.
*Probe (filter) is very sensitive to humidity changes, save the environment is very important. Do not use this table for a long time, be sure to place the probe stored in low humidity environment. Such as the probe is stored in a dry plastic bag. Proper preservation methods, probe life will be extended.
*According to the law of cosines,30Degree of the incident light, theUVProbe input signal95%. In45Degree angle,>90%. Therefore, the effective angle of incidence is45Degrees, of course, it is best to limit the30Degrees or less. Calibration, the angle of incidence should be0Degrees (vertical).
6. Canceled/Automatic shutdown
In order to extend battery life, this table has an automatic shutdown, no operation for about10Minutes, the unit will automatically shut down
To disable the automatic shutdown in the measurement“Record”, Select the memory record function.
7. Internal zeroing
In4-3Chapter of zero is normal zero steps, however,“Zero”The key adjustment range is only20Numbers, if the internal zero readings deviation beyond20Units, then“Zero”Key no longer works will be displayed:
This time is necessary for internal zero, as follows:
1) Turn off the power
2) Press the“Zero”, Turn the power button until theLCDDisplay as shown below, and then release“Zero”Key.
Uplink: Display readings of the internal zero
The downlink show: Always show“0000”
3) ModulationVR3, The read value back to zero.
8. Replace the batteries
1) WhenLCDDisplayed on the“LBT”Must be replaced when the battery, but also show low electricity can continue to use a few hours
2) To open the battery cover, remove the old batteries.
3) Mounted on the9VBattery (006P,PP3Type), replace the battery cover.
4. Measurement procedures
1) Press“Power”Button to turn on the power
2) Press“Range”Key to select the maximum range
*If the“----”, Out of range, select a similar high range.
3) Zero steps
The range to be set“199u W/cm2”
*The front of the probe Left-hand to a table or other flat surface, so that the back of upward.
*Press the zero key, the display value is zero.
4) ToUVThe probe is placed directly on the light source,LCDShown on the isUVValue.
5) Data Hold
*In the measurement process, click“Hold”Key, the reading will be locked at the same timeLCDShow“D.H”Symbol
*Click“Hold”Button to cancel data hold function.
6) Data record (maximum/Minimum value)
*Data logging function shows a maximum/Minimum reading. Click“Record”Key to begin data recording.LCDShow“REC”Symbols.
*When the“REC”Symbol is displayed when
a) Click“Recall”Key,“Max”Symbols and the maximum reading will be displayed inLCDOn.
b) Click“Recall”Key,“Min”Symbols and minimum readings will be displayed inLCDOn.
c) Click“Recall”Key to return to the data recording function, the relevant symbol disappears.
5. Measurement Considerations
*BecauseUVProbe the structural constraints, the output value of the probe may be about a year later1%Deviation, which is normal. Probe calibration cycle of one year.
*Probe (filter) is very sensitive to humidity changes, save the environment is very important. Do not use this table for a long time, be sure to place the probe stored in low humidity environment. Such as the probe is stored in a dry plastic bag. Proper preservation methods, probe life will be extended.
*According to the law of cosines,30Degree of the incident light, theUVProbe input signal95%. In45Degree angle,>90%. Therefore, the effective angle of incidence is45Degrees, of course, it is best to limit the30Degrees or less. Calibration, the angle of incidence should be0Degrees (vertical).
6. Canceled/Automatic shutdown
In order to extend battery life, this table has an automatic shutdown, no operation for about10Minutes, the unit will automatically shut down
To disable the automatic shutdown in the measurement“Record”, Select the memory record function.
7. Internal zeroing
In4-3Chapter of zero is normal zero steps, however,“Zero”The key adjustment range is only20Numbers, if the internal zero readings deviation beyond20Units, then“Zero”Key no longer works will be displayed:
This time is necessary for internal zero, as follows:
1) Turn off the power
2) Press the“Zero”, Turn the power button until theLCDDisplay as shown below, and then release“Zero”Key.
Uplink: Display readings of the internal zero
The downlink show: Always show“0000”
3) ModulationVR3, The read value back to zero.
8. Replace the batteries
1) WhenLCDDisplayed on the“LBT”Must be replaced when the battery, but also show low electricity can continue to use a few hours
2) To open the battery cover, remove the old batteries.
3) Mounted on the9VBattery (006P,PP3Type), replace the battery cover.
Contact Us
- Shenzhen Graigar Technology Co., Ltd.
- Contact nameLeo Lee Chat Now
- Phone86-755-27541660
- AddressShajing Street,Baoan District, Shenzhen, Guangdong
Product Categories
New Products
-
High-end professional anemometer HT-8393 wind meter
-
Digital professional Anemometer thermometer HT-8392 wind speed meter
-
Environmental Tester HT-856C wind speed meter Anemometer thermometer
-
Anemometer GM8902 wind tester digital anemometers wind vane anemometer
-
Anemometer GM8901 wind tester digital anemometers wind vane anemometer
-
Anemometer GM8908 wind tester digital anemometers wind vane anemometer
-
Anemometer GM816 wind tester digital anemometers
-
GM816 Digital Beaufort Wind Scale Anemometer Thermometer Speed Gauge Meter
-
Newly arrived Digital tachometer the MS6208B non-contact electrical tachometer
-
MASTECH MS6250 DIGITAL ANEMOMETER
-
MS6252A Digital Anemometer Air Volume Measurement LCD Backlight
-
0.4-30m/s, 0-99990CFM,Temp.(-20-60C),Humidity-0-100%RH,Digital Anemometer MS6252B
-
Digital Anemometer GM8901 LCD backlight display Professional Instruments 9V Battery
-
HP-856A anemometer
-
Anemometer/air flow meter HP-846A
-
HP836A Digital Handheld Portable Industrial Anemometer
-
HP816A Portable Digital Cup Anemometer
-
Anemometer GM816A wind tester digital anemometers wind vane anemometer
-
MS6252A Air flow wind anemometer, Digital Anemometer Air Volume Measurement
-
MS6252B Digital Wind Speed Meter Anemometer with temperatue&humidity USB interface
-
TL-300 Digital Air velocity / Air temperature Anemometer LCD Digital Wind Speed Meter
-
TES-1341 Hot-Wire Anemometer with USB Interface
-
TES-1340 Hot-Wire Digital Anemometer Air Wind Flow Meter TES1340
-
MasTech MS6208A Handheld Digital Tachometer Contact Tach Speedometer Automotive, electronics, etc
Popular Searches
- Smart Meter
- data concentrator
- digital meter
- Water Meter
- mechanical meter
- Water Meters
- Cold Water Meter
- Plastic Water Meter
- Dry Type Water Meter
- Jet Water Meter
- Brass Water Meter
- water meter body
- plastic body water meter
- Mechanical Water Meter
- Rotary Piston Water Meter
- billing meter
- plastic meter
- heat meter
- water meter box
- prepay meter
- smart card electricity meter
- ic card prepaid meter
- amr system
- digital electric prepaid meter
- split prepaid meter
- Remote Meter Reading System
- prepaid water meter
- smart water meter
- intelligent water meter
- digital water meter
Recommended Products
- Cast iron ultrasonic flowmeter DN125
- ultrasonic watermeter
- DN50-DN300 Large Diameter Water Meter | Class B Accuracy | Cast Iron Body | for Municipal Main Pipelines & Industrial Water Supply
- RS485/M-Bus Wired Water Meter | Easy Installation | High Stability | Direct Data Transmission | Apartment Buildings and Industrial Plants
- LoRa/LoRaWAN water meter | long distance transmission | low power consumption | remote meter reading for municipal and rural water supply
- Cat1 IoT 4G Water Meter Intelligent Prepaid Valve Control Remote Wireless Meter Reading
- Ultrasonic Heat Meter with RS485/M-Bus/Cat1 Pulse Output
- DN15-DN40 Ultrasonic Water Meter R250 Household Smart Water Meter NB-IoT/LoRaWAN/RS485/M-Bus
- carbon steel rfwn raised face weld neck flange
- ISO 4064 class b 3 inch multi-jet dry type cold brass water meter China
- electronic remote reading multi jet water meter
- DN25mm wireless multi-jet bronze cold water meter
Find Similar Products By Category
- Instruments & Meters > Meter for Liquid & Gas > Water Meter
- Please Enter your Email Address
- Please enter the content for your inquiry.
We will find the most reliable suppliers for you according to your description.
Send Now
Shenzhen Graigar Technology Co., Ltd.
AIBot OnlineThis conversation is AI-generated. Contact manufacturer before transaction to confirm info.
-
Leo Lee
Welcome to my shop, I'm glad to serve you. Please feel free to send me any questions you may have.
Your message has exceeded the limit.
- Contact supplier for lowest price
- Customized Request
- Request Sample
- Request Free Catalogs
Your message has exceeded the limit.
-
Purchase Quantity
-
*Sourcing Details
Your inquiry content must be between 10 to 5000 characters.
-
*Email
Please enter Your valid email address.
-
Mobile