Milk Pasteurizer

Specifications

Milk Pasteurizing plant

Design parameters

1. Raw milk feed temp                                 4-5c

2. Milk take off temp to separator               45-47c

3.Milk pasteurizing temp                             78-82c

4. Holding time                                             20 sec

5. Milk outlet temp                                       4c

6 Heat regeneration efficiency                   90%

7 Pressure drop milk side                          1.5 kg/cm

8Chilled water flow rate                              1:3

9. Hot water flow rate                                  1:2.5

10. Chilled water temp                               0-1c

11. Hot water temp                                     90-94c

The system will consist the following

SS balance tank:The float balance tank will be fabricated with 2 mm SS 304 sheet, with cover, sanitary float, milk out let with SS plug valve, return line ,manual flow control valve at inlet & adjustable ball feet

Milk feed pump

This will be used to transfer the milk from dump tank to milk chiller , The pump will be sanitary design as per dairy standard. It will be provided with single mechanical seal, The pump will be fitted with any reputed brand of electric motor suitable HP, The motor will be covered with SS sheet to prevent water penetration

PHE : Technical details as per milk chiller

Flow Diversion Valve: The FDV will provided to divert the milk flow to the balance tank if the pasteurization temp is on reached up to the set point

Pressure Flow Control System: one set of pressure flow control system will be provided to control the flow of milk when any scaling occurs during the running of pasteurizer to avoid any leakage of plates

Instrument & control panel

   One manually control electric panel will be provided with the unit ,consist of  all the push button station, indicator lamps, motor starters, Fuses, mccb, TPN for incoming cable

 One temp. indicating  panel for all the four points , FDV control  with hooter for low temp , all  copper cables to the PT-100, One No pressure control to avoid the any built pressure inside the plate