JY-X600 Remote Control Anti Bark Slave Dog Training Vibating Shock Collar And Leashes for Controlling Pets Behavior

Remote Pet Training Collar with LCD Display

Quick Details

Details:

1.Big LCD display.
2.100 level static / vibrate / beep can be altered by use of up & down button.
3.A tone button activates a lone on the Collar Receiver.
4.The system can be used up to 3 receivers (expandable 3 dogs).
5.The Collar Receiver will turn off if it is unused for 4 minutes.
6.Any movement will activate the collar receiver into STANDBY MODE.
7.The transmitter will go into STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minutes.
8.Rechargeable the collar receiver and waterproof.

Package Content

1x Receiver (7x3.6x3.8cm)
1x Remote control (14x5x2.8cm)
1x A/C Charger
1x USB line
1x 9V Battery ( for Remote control)
2x 19mm shock electrodes(use for Long Hair)
2x 13mm shock electrodes(use for Short hair) 
1x black nylon strap collar 
1x test light (Clips to collar and lights up to tell you the shock action is operating)
1x English Description

Packaging

How to operate this product
1. Please charge the collar first when you use this product first time.
How to charge the collar?
1) Connect the charger connector to the charging jack.
2) Turn on the collar: with a pen or paper clip, press the “On/Off” button, the collar will beep. 
3) Plug the charger into a standard outlet, the red LED light in the collar will be flash.
4) Charge the collar at least 5 hours for the first charge.
5) After fully charged, the red LED light will be light.
6) When charging is completed, replace the rubber cover.
Please Note: Low battery indicator: the collar will keep beeping for 2 minutes unless it gets charged.
2. Connect the transmitter with the collar.
How to use the transmitter?
1) Install the battery (9V) in the transmitter.
2) Press “MODE” button for 3 seconds and transmitter will be Turn On automatically. It will go into Standby Mode if do not operated for 20 seconds and will Turn Off if not operated for 2 minutes.
3) Press “MODE” button to choose the different modes (Sound, Vibration and Shock), and press the “+/-” button to set level (1-100).
4) Choose the channel (1, 2, 3) and train different 3 pets separately.
5) Press “OK” button.
6) Press “Light” Button to turn on the light.
7) In standby mode, to turn on the transmitter, press “MODE” button 5 seconds at least, then, it will wake up.