AP5130DN Bundle(11ac,General AP Indoor,3x3 Double Frequency,External Antenna,AC/DC adapter(US),United States dedicated)

Introduction

The AP5130DN is a performance-enhanced 802.11ac access point (AP) that provides a rate of up to 1.75 Gbit/s. It supports rich features and applies to high-density scenarios, including enterprise offices, airports and stations, digital trains, and stadiums, delivering ubiquitous access services.
• 3×3 MIMO (three spatial streams)
• Maximum rate: 1.75 Gbit/s
• External antenna
• 20 dBm

Features

WLAN features

• Complies with IEEE 802.11a/b/g/n/ac and passed the certification of Wi-Fi Alliance.
• Maximum rate: 1.75Gbit/s.
• Maximum ratio combining (MRC)
• Maximum-likelihood detection (MLD)
• Data unit aggregation, including A-MPDU (Tx/Rx) and A-MSDU (Rx only)
• 802.11 dynamic frequency selection (DFS).
• Short GI in 20 MHz, 40 MHz, and 80 MHz modes
• Priority mapping and packet scheduling based on a WMM profile to implement priority-based data processing and forwarding
• Automatic and manual rate adjustment (the rate is adjusted automatically by default)
• WLAN channel management and channel rate adjustment
• Automatic channel scanning and interference avoidance
• Service set identifier (SSID) hiding
• Signal sustain technology (SST)
• Unscheduled automatic power save delivery (U-APSD)
• Control and Provisioning of Wireless Access Points (CAPWAP) in Fit AP mode
• Automatically going online in Fit AP mode
• Wireless distribution system (WDS) in Fit AP mode
• Mesh networking in Fit AP mode

Network features

• Compliance with IEEE 802.3u
• Auto-negotiation of the rate and duplex mode and automatic switchover between the Media Dependent Interface (MDI) and Media Dependent Interface Crossover (MDI-X)
• SSID-based VLAN assignment
• VLAN trunk on uplink Ethernet interfaces
• 4094 VLAN IDs (1-4094) and a maximum of 16 virtual APs (VAPs) for each radio
• AP control channel in tagged and untagged mode
• DHCP client, obtaining IP addresses through DHCP
• Tunnel data forwarding and direct data forwarding
• STA isolation in the same VLAN
• Access control lists (ACLs)
• Link Layer Discovery Protocol (LLDP)
• Uninterrupted service forwarding upon CAPWAP channel disconnection in Fit AP mode
• Unified authentication on the AC in Fit AP mode
• AC dual-link backup in Fit AP mode
• Native IPv6
• IPv4/IPv6 dual stack
• IPv6 Portal
• IPv6 SAVI
• IPv4/IPv6 ACL

QoS features

• Priority mapping and packet scheduling based on a WMM profile to implement priority-based data processing and forwarding
• WMM parameter management for each radio
• WMM power saving
• Priority mapping for upstream packets and flow-based mapping for downstream packets
• Queue mapping and scheduling
• User-based bandwidth limiting
• Adaptive bandwidth management (the system dynamically adjusts bandwidth based on the number of users and radio environment to improve user experience)
• Airtime scheduling
• Multi-lane scheduling

Security features

• Open system authentication
• WEP authentication/encryption
• WPA/WPA2-PSK authentication and encryption
• WPA/WPA2-802.1x authentication and encryption
• WAPI authentication and encryption
• Supports wireless intrusion detection system (WIDS) and wireless intrusion prevention system (WIPS), including rogue device detection and countermeasure, attack detection and dynamic blacklist, STA/AP blacklist and whitelist.
• DHCP Snooping
• DAI(Dynamic ARP Inspection)
• IPSG(IP Source Guard)

Maintenance features

• Unified management and maintenance on the AC in Fit AP mode
• Automatically going online and loading configurations, and plug-and-play (PnP) in Fit AP mode
• WDS zero-configuration deployment in Fit AP mode
• Mesh network zero-configuration deployment in Fit AP mode
• Batch upgrade
• Local AP management through the serial interface or using Telnet
• Real-time configuration monitoring and fast fault location using the NMS
• System status alarm

BYOD

• Identifies the device type according to the organizationally unique identifier (OUI) in the MAC address.
• Identifies the device type according to the user agent (UA) information in an HTTP packet.
• Identifies the device type according to DHCP options.
• The RADIUS server delivers packet forwarding, security, and QoS policies according to the device type carried in the RADIUS authentication and accounting packets.

Locating Service

• Locates tags manufactured by AeroScout or Ekahau.
• Locates Wi-Fi terminals.

Spectrum Analysis

• Identifies interference sources such as Bluetooth devices, microwave ovens, cordless phones, ZigBees, game controllers, 2.4 GHz/5 GHz wireless video and audio devices, and baby monitors.
• Works with eSight to locate and perform spectrum analysis on interference sources.

Specification