Stainless steel 20m3 Paper Pulper machine/hydropulper

Standard

D type of broken pulp machine is mainly used to solve all kinds of pulp board, the loss of paper and all kinds of waste paper

Detail:

D type of broken pulp machine is mainly used to solve all kinds of pulp board, and all kinds of waste paper.
D type of the machine is in the existing traditional vertical crushing machine based on reference to foreign information design. D type pulper main features of Fu Kesi rotor deviates from the center position, the slurry and the rotor contact more quickly, the frequency is higher. The traditional hydraulic pulper generates a without hindering the swirl, paper material from the place of adding by helical line moves to the center of the rotor at, and D type pulper changed this kind of movement, make paper material more quickly and the rotor contact, so can shorten from paper material is added into broken solution treatment and improve production capacity without increasing the volume and power.
D type pulper are generally equipped with a stranding machine and sediment well, stranding machine can remove winding impurities, such as plastic packaging bags, rope, wire, etc.: recommended stranding machine types for ZTS1. The bottom of the tank body is a rectangular interface and the connected sediment well again by impurity separator to remove plastic foam and other light debris, to realize the continuous production, deposition of sediment at the bottom of the heavy impurities regularly discharged. The interface also can only achieve batch slag collecting tank weight.

The path of the paper material movement in the D type of the ground breaking machine and the traditional hydraulic machine is as follows:

                       Common Type                             D Type

Production operation of D type of ground pulp machine
(1) in the normal production, should advance to the groove body injection 1 / 3-1 / 2 volume of water, start the motor, the open rotor wash water valve, and then start the chain plate machine, raw material is gradually and uniformly input, and at any time to adjust raw material and water addition to make the slurry concentration should be reached and control the highest level from the edge of the slurry groove distance. The specific size see figure, pay attention to feeding process in preventing excessive or feeding uneven.
(2) to always check the temperature of the bearing in the operation of D type pulper process, whether the loosening of the bolts, flanges and valve is leaking, leaking slurry, the packing seal is overheating, the bearing overheating. The current is too high, found problems in a timely manner.
(3) the hard impurities in the waste paper should be cleaned in advance to avoid damage to the ground breaking machine. According to the varieties of raw materials, regularly salvage and removal of non friable solution debris. Each shift classes after the shutdown should the remaining slurry net line and remove the foreign body in the sediment tank and maintain the smooth flow of the pipeline.
(4) stop. First stop charging, and machine in the remaining slurry row net, and water supply shutdown, shutdown and remove broken slurry machine groove debris.
(5) when power failure or other special circumstances of caused by stopping the pulper, should first turn off the power switch, open the pulp plate at the bottom of the flushing water flushing, discharge of the slurry tank, pulp position as far as possible to reduce, is strictly prohibited equipment in a pulp storing more than 1 / 2 volume to start, to prevent burning motor.
(6) heavy slag D type pulper sediment wells should be cleaned regularly, to prevent pipe blockage.