Customized Environmental Temperature Humidity Walk-In Chamber for Solar Panel Vehicle Testing

 
Customized Environmental Temperature Humidity Walk-In Chamber for Solar Panel Vehicle Testing 
 
 
1. Environmental Walk-In Test Chambers Advantages:

APPLICATION FOR SOLAR PANELS

The IEC (International Electrotechnical Commission) established environmental testing methods for solar panels that include operation at 85°/85%, thus requiring solid construction chamber.

The size and number of solar panels being tested at one time benefis from full-opening doors and heavy-duty flor construction. 

Because the  conditioner is separated for shipment, these units can be more easily shipped to countries wheresolar panels are being manufactured.

Custom built chambers

Drive-in chambers are typically built using panelized construction, but can use solid construction if testing requirements demand it. KOMEG customizes each drive-in to include features to suit the client’s simulation requirements.

Additional testing conditions
Chassis dynamometer or four-post road simulator:
KOMEG builds special flor interfaces to allow use of these additional types of equipment supplied by other vendors.
Infrared lighting:
KOMEG builds infrared systems to create radiant surface heating of vehicles to look for deformation and other quality problems. These systems can be adjusted vertically and angled to ensure even coverage.
Running vehicle:
From cold-start to high-heat stress, a running engine is a common need, but complicated requirement.
Fresh air must be conditioned and introduced to the chamber to make up for that used in combustion, and exhaust must be safely removed from the chamber.

 
Main Technical Parameters
 

 
 
 
 
 
Control method and characteristics:

Precision microcomputer control temperature and humidity system, with PID control the refrigerant flow to make the system’s heating / humidification reduction, to achieve low power consumption, energy saving, carbon reduction effect, cooling, heating, humidity control intelligent electronic control, long-term stable use.
 
Flexibility for structure
The panels used in our chamber are 4” (100mm or 150mm) Thick urethane-foam sandwiched between a stainless-steel interior wall and a coated-steel exterior. An assembled box is self-supporting. So that no heavy structural members are required. Different door sizes, flooring upgrades,access ports, and other modifications are possible.
 
Widest test range, most customizable