GPS Tracker Waterproof Dog Collar

Please charge 12hours at first use.

Insert SIM card in right way. Please put the unit outside and make sure the trademark side facing up.

Confirm your SIM card have calling, send SMS, GPRS function.

Confirm your SIM card have enough balance (money).

Confirm your SIM card can show caller ID and don not use call forwarding function.

Device install and SIM card installation

Put the device near to the screw hole

Rotate device as following diagram 

Make sure that there is no call transfer and call display is on, and PIN code off. The SMS message must in Text format, can’t be identified for PDU format. 

Open the waterproof plug, put the SIM card into the card slot.  

Put the waterproof plug back to the slot,press the on/off button.

Do charge the battery to capacity in 8 -12 hours for first time. Please use the battery and charger provided by the manufacturer. This unit adopts built-in Li-ion battery, and full battery can standby 80 hours. After first use, the battery usually should be charged fully in 3-5 hours.

Cautions:

a:For it’s Li-ion battery, which contains harmful chemicals and may burst, please don’t bump, puncture it violently and keep it off fire.

b:Please charge the battery in time to keep it working normally.

Put the SIM card in place.

Turn on the unit outdoors by pressing the “on/off” button until the indicator is on.

For first use, please initialize the unit and restore it to default setting. (Please refer to 5.4 for instruction.)

 In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well as the GPS signals. The indicator will keep flashing every 3 seconds when the unit has received the signals.

 When this unit receives GPS signals normally, you can use it and do any setting as the instructions of this manual.

  Green LED for GPRS working status

  Blue LED for GPS working status

  Red LED for power charging status

Shipping Instructions

Company And Service