RGB led strip wifi controller

 The chip supported as below:

1. One signal wire- TMXX:  TM1803-TM1804-TM1812-TM1825-TM1826-TM1829-TM1925-TM1926-TM1913-TM1914-TM1915-TM1916-TM1814

                               Other: IN1504-INK1003-WS2811-UCS1903-UCS1909-UCS1912-UCS2903-SM16703-SM16709-SM16712

2. Two signal wire:  WS2801-LPD6803-LPD8806    DMX512-1990 standard protocols

RF remote control:

Operating control:

1. Power button:press"on/off" to turn on or off

2. Voice switch: press“pause" button for 3 seconds to turn on or off the environment voice

3. Sensitivity: short press"pause" button for 1-8 level cyclic adjusting sensitivity

4. Speed regulation; short press"S+" to speed up; short press"S-" to speed down

5. Static pattern: short press"B+" to next pattern; short press"B-" to last pattern

6. Dynamic pattern: short press: "M+" to next pattern; short press"M-" to last pattern

Setup steps:

1. long press"on/off" button for 3 seconds to enter the pixel width settings

2. short press "S-"  to make the first 3 pixels are lighting"RGB"

3. short press"S+" to set the led sequence, make sure the lighting sequence is "RGB"

4. short press "S+" or "S-" to set pixel height; press longer to make fast regulation

5. short press"B+" or "B-" to set pixel width; press longer to make fast regulation

6. short press "ON/OFF" button to exit setup mode