Kafuter K-9406 Epoxy Adhesive/Casting Adhesive for Corrosion Reparing

Specifications

   Kafuter K-9406 Epoxy Adhesive/Casting Adhesive for Corrosion Reparing

Typical Properties:

 Applications:

Low viscosity, can brush coating, sealing and impairing the worn pumps, valves, heating-transfer boards, basins, and oil tanks, etc. also, using as a pre-protected coating in big area surface.

Directions:

1.Surface Cleaning:

 Remove the oil and grease from the surface, also should be abrasived and polished.

2. Mixing

 Two-part, please mix and forge the two parts by equal ratio. It will become gel-formulation at the low temperature, it can change into soft gel heating by the heating producer.

 Notice: Do not heat with the open-fire

After 24h room cure, it can put into use.

3.Coating

 First, coating the surfaces with some glue, and then push and repeat coating the surface until it exhaust the air and fully fill the gap. 

4.Curing

 When the room temperature is lower than 10°C, and after 1-2 h room cure, use heat producer heating for 3-4 hour bewteen 80°C, the heating producer between the parts should keep a distance of 300-400mm. and the small-area fittings can be put into the oven for heating below 80°C.

 (Heat Producer: infra-red lamp, electric stove, and other heating sources, not use the open-fire)

 5.Post-Processing

 After cured some time, it can be processed by ordinary ways, and wait for 18 hour, it can use the machine for processing.

Packing:500g/pairs