BOBBIN SORTING MACHINE

BOBBIN SORTING MACHINE 

Equipment  Features:    

This equipment is designed for putting spinning machine twisting machine spinning tube twisting tube and weft pipes in order.It can reduce labor, reduce labor intensity and improve working efficiency.    

Specifications:        

1. Working efficiency:18000pcs/hour

2. Pass rate:≥98%

3. Motor Power: 1.1kw

4. Voltage: AC380V(Four wire three phrase)

5. Size: Length × width × height: 1820mm × 880mm × 1010mm

6. Equipment weight: 410kg

7. Suit spindle: 20000-40000 spindles/ set

8. Save labour:1~3 person/ 10000 spindles  

How it works:

Chaotic yarn tube, an enhanced belt conveyor to the beginning of the entire area. The early separation of the whole district governing board will adjust the yarn into a yarn tube axis nearly parallel with the movement west side of the state, and then through the rubber drive wheel will be transmitted to yarn tube wheel disc sub-arguments. Li-round use of sub-gap between the separation plate, forcing a small upward bulk yarn tube upside down, along with a separate round a circular motion. Yarn tube with centrifugal force and the joint action of stripping fork to make yarn from the tube and enter the level of sub-arguments wheel conveyor belt, from the level of conveyor belt will be sent to the tube yarn tube bucket.

Structural features:

1. intermediate rubber to send round, will drop its campaign yarn tube energy conversion and lead to its rapid entry into sub-arguments-round and improve effectiveness.

2.the middle of transmission rubber wheel to use than other forms of transmission will enable the machine dimensions shrink, reducing the area.

3. rubber transmission wheel and separated by a strip-board and synthetic materials, sub-grounds round the bobbins on the bobbin has been sorted out at the same time to protect and prevent the yarn tube surface can become damaged.

4. the middle rounds of rubber transmission has applied for national patent protection

Use points:

1. connected before running to meet the requirements of the power to confirm positive inversion and grounding reliable and effective.

2.to start power supply, check the status of the various operational components, with or without touch the card phenomenon.

3.Check ministries fastening bolts and nuts, check whether the partial transmission belt to run, if the deviation to use adjustable screw adjustment.

4. Regulator library's capacity and the level of the stent tube struggle to need a reasonable position.

5. the proposed width of 220mm pipe Doo Doo depth of 200mm pipe

6.For finishing weft pipes, in need of replacement equipment was reasonable round.

Installation and adjustment:

The equipment was installed in relatively flat on the ground, require legs touch the ground, no need for anchor bolts fixed.