2 FXS port; 1 USB Port VoIP Wireless Router

Hardware Installation
  Before starting to configure the router, you have to connect your devices correctly.
1) Connect Line port to land line jack with a RJ-11 cable.
    2) Connect the WAN port to a modem or switch or router or Internet with an Ethernet cable.
3) Connect one port of 4 LAN ports to your computer with a RJ-45 cable. This device allows you to connect 4 PCs directly.
4) Connect one end of the power cord to the power port of this device. Connect the other end to the wall outlet of electricity.
5) Push the ON/OFF button to power on the router.
6) Check the Power and WAN, LAN LEDs to assure network connections.
  Appearance
 
1) Front Panel

2)  Rear Panel

Ways to configure G802

There are three ways to configure G802: use IVR, use provision and use WEB GUI, recommend is WEB GUI. And you can configure only some parameters through IVR, like WAN port IP address, WAN port IP mode, Subnet mask and so on. User presses **** to start IVR, and the IVR will lead you to configure. Every time you finish some changes, you may need reboot G802 to make the changes effective. Details about IVR, please refer to G802 user manual. Provision is also a convenient way to make configurations, to get more information about provision, please refer to provision user manual. And you can configure all the parameters of G802 through WEB GUI, login to G802's webpage, then you can begin to configure.
Following picture is the login page of G802 :

And Status page of G802:

User wants to use G802 as a wireless router need to configure in G802's network and wirless page. Details about configuration, please refer to user manual. The wireless page of G802: