acrylic polishing machine G90

Specifications

nonmetal polishing amchine G90 

1, The electrolyte is alkaline and may hurt skin and eyes. Avoid direct contact while preparing electrolyte; let out the remaining gas before adding water to avoid the electrolyte spurting out. If stained on skin or in eye carelessly, wash with lots of water.

2, After the first time of use, only water-the “fuel“ need to added timely. Don‘t add electrolyte.

3, Theoretically, the electrolyte can be used permanently. However after about 3 months of operation it will because of losing efficacy. To change electrolyte, open the outlet in the bottom of the generator and drain off the dirty electrolyte, wash the electrolyte case with pure water, then screw on the outlet. Prepare and add new electrolyte. This is to keep the electrolyte case clean, thus avoiding the erosion of electrodes.

4, The water level should not excess the “high” line, or the liquid in gas filter may overflow, if so, pour out the excessive electrolyte. The best water level is close to “high” line.

5, Water in rubber pipe may cause the flame turn red or yellow. If so, take off the torch and check the gas filter to drain the water out of the pipe.

6, Avoid gas leak at the connecting parts. Change the rubber pipe in time if it aged.

7, The controlling electro circuit of the generator is designed specially. Do not disassemble it.

8, Do not let the flame towards human or combustible.

9, Cold boiled water or tap water can be used as substitute of distilled water, but mineral water is not suitable.

10,If backfire occurs (even with exploding), do not panic. Destructive test proves the protective design can assure the safety of the operator. Backfire may be caused by improper operation, gas leak, torch malfunction or higher pressure. Check the pipe, add backfire-proof fitting or change a torch may solve the problem. Before that, it’s better to contact the manufacturer for technical 

1, The electrolyte is alkaline and may hurt skin and eyes. Avoid direct contact while preparing electrolyte; let out the remaining gas before adding water to avoid the electrolyte spurting out. If stained on skin or in eye carelessly, wash with lots of water.

2, After the first time of use, only water-the “fuel“ need to added timely. Don‘t add electrolyte.

3, Theoretically, the electrolyte can be used permanently. However after about 3 months of operation it will because of losing efficacy. To change electrolyte, open the outlet in the bottom of the generator and drain off the dirty electrolyte, wash the electrolyte case with pure water, then screw on the outlet. Prepare and add new electrolyte. This is to keep the electrolyte case clean, thus avoiding the erosion of electrodes.

4, The water level should not excess the “high” line, or the liquid in gas filter may overflow, if so, pour out the excessive electrolyte. The best water level is close to “high” line.

5, Water in rubber pipe may cause the flame turn red or yellow. If so, take off the torch and check the gas filter to drain the water out of the pipe.

6, Avoid gas leak at the connecting parts. Change the rubber pipe in time if it aged.

7, The controlling electro circuit of the generator is designed specially. Do not disassemble it.

8, Do not let the flame towards human or combustible.

9, Cold boiled water or tap water can be used as substitute of distilled water, but mineral water is not suitable.

10,If backfire occurs (even with exploding), do not panic. Destructive test proves the protective design can assure the safety of the operator. Backfire may be caused by improper operation, gas leak, torch malfunction or higher pressure. Check the pipe, add backfire-proof fitting or change a torch may solve the problem. Before that, it’s better to contact the manufacturer for technical