SK6812 APA102 WS2812B WS2801 TM1814 IC RGBW RGB LED controller

MATCH SETTING RED GREEN BLUE WHITE

Testing
Continuously pressing the AUTO button 5 times until LED is out, release the AUTO button to into the mode of switching in red,green,blue,yellow,purple,cyan and white,witch to test the your LED.

Matching
Continuously pressing the MATCH button 5 times until LED flash in white quickly to match the Remote control with the receiving controller.Pressing the MATCH button for 5 times till LED flash in white slowly to un-match;

Reorder RGB 

Differ from kinds of LED, The R G B keys may don’t perfectly match to your LED,Reorder them if needed. Continuously pressing the SETTING button 5 times until LED flash in white once and then turn into all white,Pressing the R button until LED is red, Pressing the G button
until LED is green, pressing the B button till LED is blue, then press the SETTING button once to confirm your setting;

Adjust Num of pixels
The factory default setting of the number of controlled pixel is 600. Continuously pressing the SETTING button 5 times until
LED flash once and turn all white, pressing MODE+ to add pixels ,pressing MODE- to decrease pixels,(each pressing add or decrease
60 pixels) then press the SETTING button to confirm your setting;Can be regulated to up to 2048 pixels,The minimum number is
300 pixels.

Catching
When in the AUTO mode, pressing the SETTING button once,and then press MATCH button once to catch the Current pattern to stay and
operate circularly.

3.Receiving Controller:
Can be customized to support almost every kind of one-wire or two-wire LED-DRIVER-IC;
The receiver controller has two kinds of working voltage :5V-supply-voltage or 12V-supply-voltage;
Cautions: Please make sure the power supply voltage is match to your controller before you power it.