NLOS Long Range HD Digital COFDM Video Transmitter Board SG-TX1080

NLOS Long Range HD Digital COFDM Video Transmitter Board (SG-TX1080)

NLOS Long Range HD Digital COFDM Video Transmitter Board SG-TX1080 has a small volume and low power consumption. 

With H.264 compression code, COFDM modulation, highly integrated embedded design ,single-chip digital modulation processing technology and ultra-linear digital pre-distortion (Digital Predistortion) RF design, SG-TX1080 is combined with digital capture, encoding, modulation and fullband RF output, so SG-TX1080 supports HD1080P HD transmission.

SG-TX1080 is widely used in  hd digital live broadcast, defense, public security, armed police, security and other areas of applications.SG-TX1080's excellent design makes you easier, simpler, and more effective to fit with standard hd wireless COFDM video transmitters and receivers.

 (1) LED panel:FM board’s parameter display screen
(2) To connect external transmitter board’s plug (3.3V,GND,RX,---- correspond to above picture(5) one by one .
(3) Control Keys:HD FM board parameters control keys(Up, down, left, right, OK)

Description

First connect the antenna to the AV cables ,and then all the accessories connected well. After power on,the transmitter LED display flash a few times, then become stable. Long Press 2 seconds the "Menu" ,then where the place need to be changed will become to deep black.Via pressing the up and down keys to adjust the figures.After finish it,long press the Menu 1.5S to access locking and stability.

Display as following :
"State" stand for the strength of received signal,the greater the percentage, the stronger the signal;
"Freq" stand for the HD receiver frequency.
"Band" disply the bandwidth, 2/2.5/4/ 8M are for your optional; HD is commonly 4M.
"PoE" and "AES" are encryption Status;OFF means “NO”,ON means “YES”.
Operation:
You can set up the system parameters on Receiver's front panel via the Menu key (LEFT_RIGHT), by moving the cursor left and right to move to the position you want to modify the values.Then by using the UP or DOWN to modify or select the parameters required. when the cursor is moved to the last one on the right, long press the menu key (LEFT_RIGHT) 2 seconds, and then save the current set of parameters, it will be constant.By using the Increasing key (UP) and decrease key (DOWN), you can modify the value or select a value.