led soldering machine,benchtop reflow oven,infrared heater,mini reflow oven,smt machine

1、Enter into the setting interface when starts the machine.(temperature zones from left to right 1/upper 3/upper 5/upper , 2/down 4/down6/down；face the swift of machine，(temperature zones from left to right1/upper 3/upper 5/upper , 2/down 4/down6/down）.

2、 Rotate Param button slowly to move the white cursor, when button move counterclockwise,white cursor up. When white cursor refers to the parameters need changed, slowly rotate value key to change parameter, when rotating value key clockwise ,the parameter bigger,when rotating value key counterclockwise, the parameter shrunk. The SPD is belt transmission speed setting, PRFV is wave number set.

3、 After the parameters changed, press the value button for long time, until the screen reads “successfully”,parameters saved successfully.

4、 Press param button long time to enter work interface, the oven start to run the wave.

5、Press param button long time to return to setting interface to re-set other waves.

6、After the wave set, only need to change the wave number of PRFV then select the wave.

7、Six small red switch, control the six tempreture zone lamp.

8、 Attentions:

Each temperature wave purposes as follows:

Wave one and two: use the same with soldering the less lead paste, like 85Sn/15Pb 70Sn/30Pb

Wave three and four: use the same with soldering the more lead paste, like 63Sn/37Pb 60Sn/40Pb.

Wave five and six: use the same with soldering high-melting-point Warm prompt: the machine after shutdown, if you want to restart, the interval of at least 5 s

Wave seven and eight: use the same with soldering lead-free solder in melting point, like Sn/Ag2.5/Cu.8/Sb.5；Sn/Bi3.0/Ag3.0

1. According to the chips size and welding technological requirements, select the proper wave.

2. There are lot kinds of solder paste, every company chooses is also not identical. For these reasons, we design this product can set eight waves, each wave has three sections, each section of the heating time and temperature all can alter. You can reset the heating waves according to the solder required heating temperature and time.

Warm prompt: the machine after shutdown, if you want to restart, the interval at least 5 s.