Remote Control Spray Training Collar for Dog

1).Make sure that batteries are installed in the remote controller. Press the button on the remote controller, the indicator light will light.

2). Checking the remote controller: Press the buttons on the remote controller one by one, the indicator light will light. If the indicator light doesn’t light or goes dim, change the batteries.

3). There are seven buttons on the remote controller, the three buttons on the right send out action orders , the three buttons on the left send out warning spray, and the button in the middle is the calling button .

4).There is a magnetism induction power switch in the receiver. The part with blue spot in the bottom of the remote controller is magnetic. When the blue spot part of the remote controller approach to that of the receiver, the indicator light near the blue spot part of the receiver will flash. If it keep lighting after flashing about 3 seconds, that means the power switch of the receiver is on. If it doesn’t light or goes dim, it means it is short of power., then you should charge the battery with the special charger. Let the blue spot part of the remote controller approach to that of the receiver again, the indicator light will flash, and it will go out after flashing about 3 seconds, which indicates that the power of the receiver is off.

5). Checking the receiver: press the buttons 4.5.6 on the left one by one , the spray will come out from the receiver , to stop the dog’s bad behaviors.

6). Pressing the three buttons on the right can make three different kinds of BB sounds, standing for three action orders or intentions from the master. Train the dog to let it understand and remember.

7). Press the button in the middle of the remote controller, the receiver will make a SOS Morse Mode sound , it can be used to call the dog.

8). Every time you press the buttons on the remote controller , the receiver will vibrates ,make sounds or send out spray correspondingly . You should let the pet know what should be done and what should not be done. After a number of trainings the pet will understand what you like and don’t like.

9). Adjust the length of the collar to fit the neck of the pet. The proper tightness should be that you can insert a finger in between.

10). Prepare some socks for the dog as rewards for good deeds. This will make better effect in the training.

2) Rang up to 300 meters (in open field);

3) 3levels of spray +3 levels vibration +Beep

4)Both remote transmitter and collar receiver could set up POWER MANAGEMENT when not in use;

5)Suitable for healthy dogs of over 6 months old.

6)Featured power saving design

7)Certificate: CE/R&TTE/ROHS