Clay Sand Vibrating Boiling Cooling Bed

            Clay Sand Vibrating Boiling Cooling Bed

After this series of products are mainly used for regenerative cooling in addition to the film also has except the metal particles, in addition to membrane powder crumbs, and other functions, this device is a continuous cooler, the boiling state into the fluidized bed of loose sand, from the start into the sand around the coil meander, under the action of wind and water, fully cooling, sand and sand mouth, discharged during the boiling widely in the dust to dust, guarantee the recycling sand process requirement.

Working principle:

Work, sand of sand mouth fell to boiling plate, blower made the sand on the airflow through the boiling plate fluidized, then from below the baffle into the cooler.Sand into the cooler is through the rotation of the blowing of the wind currents, from the top down to the bottom of the plate into the adjacent small room, and then by another exhaust nozzle airflow, driven across the top of partition into a small room.Side and sand boil, a face to the right, and constantly contact with the cooling water pipe in the small room for heat exchange, the sand cooling, cooling water temperature is controlled by a special system.In the process of sand fluidization, sand friction each other, can remove the residual resin film, dust discharge currents through the dust removal system, the cooling sand by sand discharging chute after release.

Main models;